Lg Range LDG5315ST Parts

Secures the gas burner nozzle in your range cooktop. Replace this holder if it's cracked, broken, or no longer holding the nozzle firmly in position.

Replace your range's control board support bracket if the PCB is loose or unstable. This mounting bracket secures the circuit board. DIY-friendly repair.

Replacement screw for electric and gas ranges. Secures panels, brackets, and internal assemblies. Restores tight fit when original is missing or stripped.

This bracket secures the turntable motor to the microwave oven cavity base, keeping the motor properly aligned so the glass tray can rotate smoothly for even heating.

• Supports and positions the turntable motor beneath the oven floor
• Helps resolve issues like a non-turning glass tray or jerky rotation
• May correct intermittent grinding or scraping noises from the tray area

• Unplug microwave before servicing; high-voltage components can retain a charge
• Remove the unit from its install location if required for bottom access
• Access turntable motor from the underside; support the cavity to prevent damage
• Reuse existing screws and motor unless otherwise specified

Fix control issues or power failures with this gas range cable assembly. Restores reliable operation when wiring is damaged, burned, or has loose connections.

Bracket that anchors the handle to your range oven door. Replace if cracked, stripped, or broken to restore secure handle attachment and alignment.

If your gas cooktop burner won't ignite, flames are uneven, or the burner head is damaged, this surface burner assembly restores proper heating and flame control.

Fixes weak or uneven flames on gas range burners. This nozzle meters fuel flow to each burner for balanced heating. Direct replacement part.

Lower cabinet support base that stabilizes your range and protects internal components. Replace if cracked, broken, or causing wobble for secure mounting.

Fix burners or oven not lighting with this gas valve assembly. Controls gas flow to restore safe ignition and consistent heating in your range.

This heater cover protects the dryer heater assembly and helps direct airflow for proper heating performance. It replaces a cracked or damaged cover to restore safe operation and part alignment. What it does:

• Shields the heating element and internal components from debris and accidental contact
• Helps channel airflow through the heater for efficient drying
• Can prevent rattling or vibration caused by a loose or broken cover
• Common symptom: damaged cover may be noticed when replacing the heater or after impact/overheating

• Disconnect power before accessing the heater assembly; allow components to cool fully
• Follow the appliance service manual for disassembly/reassembly and use correct fasteners
• Inspect adjacent components (heater element, terminals, mounting clips) and replace if damaged

This is a gas safety valve used in a gas range that controls the flow of gas to the burners or oven. It works with the ignition system to ensure gas is only released when proper ignition is detected. Replace this valve if the oven or burners fail to ignite, gas flow is inconsistent, or the valve does not shut off gas properly when the burner is turned off.

This is a replacement screw used to secure appliance components and panels. It restores proper fastening where a stripped, missing, or damaged screw causes loose parts or rattling. What it does:

• Fastens panels, trim, or internal components to maintain structural fit
• Helps stop vibration-related noise from loose assemblies
• Replaces missing or corroded screws that prevent proper closures
• Restores secure mounting after repairs or disassembly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not over-torque to prevent thread damage
• Keep small parts away from children and pets
• Disconnect power or water before accessing internal parts

Fix intermittent power issues or control failures with this range main wiring harness. Connects electrical components for proper signal communication.

Burner cap for gas ranges. Fits over the burner assembly to protect from debris and damage. Replace if cracked, chipped, or missing for proper operation.