Lg Microwave LHE9674PA Parts

This customized screw secures appliance panels and small components, restoring proper fit and reducing noise from loose parts. Designed to match the original fastener for a correct fit and function. What it does:

• Fastens trim, panels, brackets or internal components to prevent movement and rattling
• Replaces missing or stripped screws that cause loose parts or gaps
• Helps maintain proper alignment of panels to improve appearance and sealing
• Matches original screw profile so mounting points engage correctly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• Keep small parts away from children and pets

This outer access panel replaces a damaged or worn cover to restore the washer/dryer's exterior protection and appearance. It keeps internal components shielded while maintaining a clean, finished look for the appliance. What it does

• Protects internal components from dust, debris and accidental contact
• Restores a secure outer surface to appliances with cracked or missing covers
• Helps maintain proper airflow and component alignment around the covered area
• Reduces risk of damage to controls or wiring exposed behind the panel

• One replacement outer access cover

• Verify power is disconnected before starting any repair
• Remove retaining screws or clips holding the old cover; handle panels carefully to avoid scratches
• Align the replacement cover and secure with the original fasteners

This adjustable leveling foot replaces a worn or damaged support leg to stabilize and level your appliance. Restores proper balance to reduce rocking, uneven doors, and vibration for safer operation. What it does:

• Provides an adjustable contact point to level the appliance on uneven floors
• Helps stop rocking, tipping, and excessive vibration
• Restores correct appliance alignment for proper door/drawer operation
• Prevents uneven wear on internal components caused by imbalance

• Disconnect power and water before accessing underside of the appliance
• Raise or support the appliance safely — use a jack or have a helper to avoid injury
• Thread the foot into the mount and adjust height until the appliance sits level; tighten any lock nuts if present
• Test stability on all corners and recheck after a short test cycle

This replacement leveling foot supports and stabilizes the appliance cabinet, helping restore proper balance and reduce rocking or uneven operation. It's a simple, durable part used where the appliance meets the floor. What it does

• Provides a stable contact point between the appliance and the floor to reduce rocking and vibration
• Restores correct cabinet height to help doors and drawers align and close properly
• Helps maintain even load distribution during operation to reduce noise
• Works as a direct replacement for worn, cracked, or missing feet that compromise stability

• Turn off and unplug the appliance before inspecting or replacing feet.
• For washers/dryers, tip or raise the unit per manufacturer guidance to access the foot; use two people if needed.
• Adjust the foot height so the appliance sits level on all sides and does not rock.

This replacement foot helps stabilize and level your appliance to stop rocking and protect floors. Made to match the original mounting and support weight at a cabinet corner or base, it restores safe, even operation. What it does:

• Supports the appliance base and transfers weight to the floor
• Allows fine height adjustment to correct uneven or tilted placement
• Reduces rocking, vibration, and floor damage from an unstable appliance
• Restores proper alignment for doors and panels that bind when unlevel

• One replacement foot as shown

• Disconnect power and water and move the appliance to access the foot safely
• Raise or support the unit before removing the old foot to avoid sudden shifts
• Thread or press the foot into place per the original mounting; adjust height until the appliance sits level
• Wear gloves and eye protection; follow OEM instructions if available