Lg Refrigerator LMRS28596D Parts

LED light assembly for refrigerator interior lighting. Installs in fresh food or freezer compartment. Replace if cracked, dim, or not illuminating properly.

Seals the refrigerator door to prevent cold air leaks, frost buildup, and temperature fluctuations. Replace if torn, cracked, or no longer sealing tightly.

Support roller that mounts to the refrigerator base, allowing the unit to roll for cleaning or service. Replace if worn, broken, or causing uneven positioning.

Replacement fresh room tray assembly for bottom-mount refrigerators. Restores deli drawer storage when original is cracked, broken, or missing.

This is the glass or plastic cover that sits on top of the crisper drawers in the fresh food compartment, serving as both a shelf and a humidity barrier for the produce drawers below. It typically includes the frame and any attached supports. Replace this cover if it is cracked, broken, or if the crisper drawers are no longer maintaining proper humidity levels for fruits and vegetables.

Fix inaccurate temperature readings or sensor errors with this refrigerator sensor control board. Restores proper sensor communication and feedback.

Complete freezer door assembly that restores proper sealing and cold retention. Replace when damaged, cracked, or not sealing properly. Confirm fit with your model number before ordering.

This harness assembly restores the electrical connections between components, replacing a damaged or worn wiring harness to help re-establish reliable power and signal paths for the appliance. What it does

• Replaces a damaged or frayed wire harness that can cause intermittent or no power to components
• Restores factory wiring routes and connector fit to ensure correct electrical signaling
• Prevents shorts or open circuits caused by broken wires or loose terminals
• Helps resolve symptoms like components not powering, erratic operation, or connector damage

• One harness assembly as shown

• Disconnect power and any water supply before starting; confirm appliance is fully de-energized
• Compare connectors and wire lengths to the original part before installation
• Route harness along factory clips and secure fasteners to prevent pinching or chafing

This pipe holder is a small plastic clip that secures tubing and small pipes inside the appliance, helping keep lines organized and preventing rubbing or disconnection. It restores proper routing and reduces vibration-related noises. What it does:

• Holds and secures water, drain, or refrigerant tubing to prevent sagging and chafing
• Keeps lines routed away from moving parts to reduce wear and noise
• Helps maintain proper tube alignment to avoid strain on fittings
• Commonly replaced when the original clip is cracked, broken, or missing

• Disconnect power and water before working on the appliance
• Inspect surrounding tubing and fittings for damage when replacing the clip
• Typically installs as a push-fit or snap-on clip; use gentle pressure and avoid forcing
• Replace broken or brittle clips to prevent tubing damage or leaks