Lg Microwave LMS1170SS Parts

Microwave won't heat? A failing high-voltage capacitor disrupts the heating circuit. This part stores electrical energy for consistent operation.

Truss head tapping screw secures panels, brackets, and covers in appliances. Replaces missing or damaged fasteners to restore snug fit and alignment.

A Tap-Tite binding-head screw used to fasten appliance panels and components where a self-tapping metal thread is required. Replaces missing or damaged fasteners to restore secure assembly and reduce vibration or rattling. What it does:

• Creates its own mating thread in thin sheet metal for a secure hold without a nut.
• Holds panels, brackets, and trim in place to prevent looseness or movement.
• Commonly used where stripped, missing, or broken screws cause rattling, misalignment, or parts that won't stay attached.
• Compatible with standard screwdrivers or nut drivers sized to the binding-head.

• Disconnect power and unplug the appliance before working on it.
• Use the correct driver bit to avoid cam-out or head damage.
• Start straight and apply steady pressure; avoid overtightening to prevent stripping the formed threads.
• If the original hole is badly damaged, assess for repair or use of a larger fastener as needed.

Microwave won't start or door won't stay closed? This door latch secures the door so your microwave operates properly. Simple DIY fix in minutes.

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

Microwave door frame assembly that surrounds and supports the door panel. Replace this structural component if your frame is cracked, warped, or damaged.

Secures the door latch assembly to the microwave cabinet. Replace if the holder is cracked, broken, or missing to restore proper door alignment.

Replace worn, cracked, or missing door seal tape on your microwave. This adhesive strip installs around the door frame to maintain proper sealing.

Replace a microwave fan motor when your microwave overheats, shuts off unexpectedly, or the cooling fan stops running. Direct-fit replacement part.

This outer case is the exterior cabinet panel that protects internal components and gives the appliance a finished look. It restores appearance and helps keep internal parts clean and secured. What it does

• Replaces a damaged, dented, cracked or corroded exterior cabinet panel
• Restores proper fit and alignment of the appliance's outer shell to reduce gaps and rattles
• Protects internal components from dust, moisture and incidental contact
• Helps return the unit to its original appearance and structural enclosure

• One outer case — the single exterior cabinet panel as shown

• Disconnect power (and water if applicable) before starting any repair
• Handle edges carefully — metal panels may have sharp edges
• Installation typically requires removing trim and fasteners; keep hardware organized
• Refer to the manufacturer instructions for disassembly steps and torque specifications