Lg Microwave LMV1751ST Parts

Complete mounting hardware kit for securing your microwave to cabinets or above the range. Includes all necessary brackets, screws, and fasteners.

Fix a microwave door that won't close or latch properly. This door latch holder secures the latch assembly for reliable door alignment and operation.

Microwave overheating or shutting off unexpectedly? This high-limit thermostat monitors temperature and cuts power if it gets too hot. Easy DIY fix.

This is a replacement screw used to secure appliance components and panels. It restores proper fastening where a stripped, missing, or damaged screw causes loose parts or rattling. What it does:

• Fastens panels, trim, or internal components to maintain structural fit
• Helps stop vibration-related noise from loose assemblies
• Replaces missing or corroded screws that prevent proper closures
• Restores secure mounting after repairs or disassembly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not over-torque to prevent thread damage
• Keep small parts away from children and pets
• Disconnect power or water before accessing internal parts

Metal bracket that secures the control panel to the console. Replace if the original is cracked, bent, broken, or missing to restore stable panel alignment.

This is a metal plate that covers the vent duct area on an over-the-range microwave, directing airflow from the ventilation system and protecting internal components. It helps channel exhaust air properly when the microwave's vent fan is in use. Replace this plate if it is dented, corroded, or missing, as a damaged cover can reduce ventilation efficiency and allow grease or debris to enter internal areas.

Fix a microwave that won't heat with a new magnetron. This part generates the microwave energy needed for cooking. Moderate DIY repair, 1-2 hours.

Plastic film covers holes in the microwave inner door frame. Replace if bubbled, burned, cracked, or peeling. Attaches to door glass assembly.

A Tap-Tite binding-head screw used to fasten appliance panels and components where a self-tapping metal thread is required. Replaces missing or damaged fasteners to restore secure assembly and reduce vibration or rattling. What it does:

• Creates its own mating thread in thin sheet metal for a secure hold without a nut.
• Holds panels, brackets, and trim in place to prevent looseness or movement.
• Commonly used where stripped, missing, or broken screws cause rattling, misalignment, or parts that won't stay attached.
• Compatible with standard screwdrivers or nut drivers sized to the binding-head.

• Disconnect power and unplug the appliance before working on it.
• Use the correct driver bit to avoid cam-out or head damage.
• Start straight and apply steady pressure; avoid overtightening to prevent stripping the formed threads.
• If the original hole is badly damaged, assess for repair or use of a larger fastener as needed.

Reduces cooking odors in your microwave. Replace every 6 months for optimal performance. Confirm fit with your model number before ordering.