Lg Microwave LMV2055ST Parts

Mounting bracket that secures the control panel assembly to the microwave frame. Replace if cracked, bent, or broken to restore proper panel alignment.

This is a metal plate that covers the vent duct area on an over-the-range microwave, directing airflow from the ventilation system and protecting internal components. It helps channel exhaust air properly when the microwave's vent fan is in use. Replace this plate if it is dented, corroded, or missing, as a damaged cover can reduce ventilation efficiency and allow grease or debris to enter internal areas.

Interior bottom plate panel for microwaves. Covers and protects the oven floor from spills and debris. Replace if cracked, warped, stained, or missing.

Fastener nut secures internal components in your microwave. Replace if stripped, rusted, or missing to restore tight hold and proper panel alignment.

Plastic cover that encloses and protects the stirrer fan assembly. Replace if cracked, melted, warped, or missing to keep debris out of the fan area.

This is a motor start/run capacitor that helps the appliance's motor start and run smoothly by supplying a brief boost of electrical energy. Replacing a failing capacitor restores reliable motor startup and operation. What it does:

• Provides the brief electrical surge needed to start and keep the motor running
• Commonly linked to motors that hum, fail to start, or run intermittently
• Helps prevent overheating from repeated start attempts when functioning properly
• Works with the appliance's start circuitry to ensure consistent performance

• Disconnect power to the appliance before accessing electrical components
• Discharge the capacitor and use insulated tools
• Observe polarity/terminal layout and secure connections to factory specifications
• Dispose of the old capacitor according to local electronic-waste regulations

A Tap-Tite binding-head screw used to fasten appliance panels and components where a self-tapping metal thread is required. Replaces missing or damaged fasteners to restore secure assembly and reduce vibration or rattling. What it does:

• Creates its own mating thread in thin sheet metal for a secure hold without a nut.
• Holds panels, brackets, and trim in place to prevent looseness or movement.
• Commonly used where stripped, missing, or broken screws cause rattling, misalignment, or parts that won't stay attached.
• Compatible with standard screwdrivers or nut drivers sized to the binding-head.

• Disconnect power and unplug the appliance before working on it.
• Use the correct driver bit to avoid cam-out or head damage.
• Start straight and apply steady pressure; avoid overtightening to prevent stripping the formed threads.
• If the original hole is badly damaged, assess for repair or use of a larger fastener as needed.

Microwave overheating or shutting off? This cooling fan assembly restores proper airflow to control components. Direct-fit replacement for failed units.

Replace your damaged or warped microwave outer door frame to restore proper fit and seal. Ensures stable door support and correct closure. Verify fit.

Microwave not heating evenly or turntable wobbling? This glass turntable plate rotates food for consistent heating. Simple 2-minute swap—no tools needed.

Mounting bracket that secures internal microwave components. Replace if your original bracket is cracked, broken, worn, or missing to restore stability.