Lg Range LRE5602 Parts

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

This is a packing gasket that seals the oven door to the range cabinet, preventing heat from escaping during cooking. It is made of a flexible, heat-resistant material that lines the perimeter of the oven door. Replace this gasket if you notice excessive heat escaping from around the door, uneven cooking temperatures, or if the gasket is visibly worn, torn, or hardened.

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

Replace your worn range oven door gasket to restore proper heat sealing and improve cooking efficiency. Verify fit with your model number before ordering.

The range packing seal creates an airtight barrier around oven doors or other range components to maintain proper cooking temperatures and prevent heat loss. Positioned around door edges or component joints, it needs replacement if heat escapes, cooking becomes uneven, or the seal appears cracked or compressed.

Structural support bracket that holds and stabilizes internal range components. Replace if cracked, broken, or missing to restore proper alignment.

Replace a damaged or corroded wire harness in your range. This single-connection harness restores proper electrical connections when original wiring is frayed, melted, or broken.

Replace a damaged or corroded range wiring harness that connects electrical components. Needed when the original harness is frayed, melted, or broken.

Replacement slide stopper for range oven racks. Secures the rack sliding mechanism in place. Order a new stopper if yours is broken, cracked, or missing.

This replacement door frame restores the exterior trim around the appliance door for a finished appearance and proper panel alignment. It helps seal and support the door while keeping the control area and window secure. What it does:

• Replaces damaged, cracked, or warped door trim that can cause gaps or misalignment
• Restores proper fit between the door and cabinet to help reduce drafts and vibration
• Supports the door glass/window and outer panel for safe, consistent operation
• Improves appearance by covering chips, dents, or cosmetic wear

• One door frame

• Designed for direct replacement; part number matches your appliance before ordering
• Remove power and follow the manufacturer's service manual for disassembly to avoid damage
• Handle glass and trim edges carefully; wear gloves and eye protection
• If clips or screws are missing or damaged, replace them with OEM fasteners for secure fit

This front plate is the outer trim panel that restores the appliance's appearance and protects internal components from debris and damage. It provides a clean, finished look and replaces scratched, dented, or missing front trim. What it does:

• Covers and protects the appliance front and control area from spills, dust, and impact
• Restores the exterior finish and alignment for a uniform appearance
• Helps keep internal components shielded from contaminants that can cause malfunctions
• Reduces gaps or misalignment that can interfere with door/hinge fit or seal

• One front plate

• Disconnect power (unplug or turn off breaker) before beginning any repair
• Removal typically requires taking off outer trim or door panels—use proper tools to avoid damaging adjacent parts
• Handle edges carefully; metal/plastic pieces may have sharp edges
• Follow the appliance's service manual or model-specific instructions for correct alignment and fastener torque