Lg Range LRG5115 Parts

Replace a damaged or corroded wire harness in your range. This single-connection harness restores proper electrical connections when original wiring is frayed, melted, or broken.

Replace a burner assembly when flames are uneven, won't ignite, or produce yellow flames. This repair typically takes 15-30 minutes with basic tools.

This cover assembly replaces a damaged or missing poise cover to restore the appliance's exterior appearance and protect internal components from debris. It fits into the original mounting points for a clean, factory look. What it does:

• Shields internal components and wiring from dust and accidental contact
• Restores the appliance's exterior finish and alignment where the poise cover is worn or broken
• Helps prevent debris ingress that can lead to noise or wear over time
• Matches OEM fit to maintain proper clearances and panel alignment

• One cover assembly

• Recommended for technicians or experienced DIYers; disconnect power before starting any repair
• Use original fasteners and follow the OEM diagram for correct orientation and secure mounting
• Inspect surrounding clips and screws and replace any that are damaged to ensure a proper fit

Wire harness for gas ranges. Connects electrical components inside your range. Replace if wires are frayed, damaged, or connections are loose or broken.

Fix a humming or stalled range component with this AC synchronous motor assembly. Restores proper rotation when the motor fails to turn or makes noise.

Replace a gas range burner when flames are uneven, won't ignite, or produce yellow flames. Direct swap installation takes 10-15 minutes with basic tools.

Burner not heating or heating unevenly? This surface element restores full heat output on your range. Straightforward DIY fix in under an hour.

Protective cover that fits over the burner head on your gas range cooktop. Replace if cracked, chipped, broken, or missing to restore appearance.

This burner cap is the top cover for a gas cooktop burner that protects the burner head and helps promote an even flame for consistent cooking. It restores proper flame pattern and appearance when the cap is damaged or missing. What it does:

• Covers and shields the burner head from spills and debris
• Helps shape and stabilize the burner flame for even heating
• Prevents food and liquids from clogging the burner ports
• Symptoms it can fix: uneven or sputtering flame, visible damage or missing cap, burner not seating properly

• Ensure cooktop is completely cool and gas is turned off before handling
• Lift old cap straight off the burner; set the replacement cap down evenly on the burner head
• No special tools required for most installs; verify correct seating so the cap sits flat
• Replace if cracked, warped, or severely corroded to ensure proper flame performance

Insulator for electric and gas ranges. Installs between internal components to provide heat or electrical protection. Replace if cracked or missing.

Flexible door seal gasket that maintains a tight closure on your range, preventing heat loss and improving cooking efficiency. Replace if worn, cracked, or loose.

Gas pipe for range gas supply connection. Replaces damaged, corroded, or leaking pipes. Essential for safe gas flow from supply line to burner assembly.

This is a replacement pipe used in the appliance's water/ice system to route water between components and maintain proper water flow. Replacing a damaged pipe restores reliable water delivery and helps prevent leaks. What it does:

• Carries water between the inlet, dispenser, and/or ice maker components
• Stops or reduces leaks when a cracked or corroded pipe is replaced
• Helps restore normal water flow if an internal blockage or break caused reduced dispensing
• Maintains proper routing to prevent kinks or stress on fittings

• Turn off the appliance power and shut off the household water supply before starting.
• Remove only the damaged pipe and install the matching replacement; use the same routing and fittings.
• Tighten fittings to manufacturer torque guidance and check all connections for leaks after restoring water.