Lg Range LRG5115ST Parts

Replace a burner assembly when flames are uneven, won't ignite, or produce yellow flames. This repair typically takes 15-30 minutes with basic tools.

Replace a gas range burner assembly when flames are uneven, burner won't ignite, or produces weak heat. Moderate DIY repair in 30-45 minutes.

This cover assembly replaces a damaged or missing poise cover to restore the appliance's exterior appearance and protect internal components from debris. It fits into the original mounting points for a clean, factory look. What it does:

• Shields internal components and wiring from dust and accidental contact
• Restores the appliance's exterior finish and alignment where the poise cover is worn or broken
• Helps prevent debris ingress that can lead to noise or wear over time
• Matches OEM fit to maintain proper clearances and panel alignment

• One cover assembly

• Recommended for technicians or experienced DIYers; disconnect power before starting any repair
• Use original fasteners and follow the OEM diagram for correct orientation and secure mounting
• Inspect surrounding clips and screws and replace any that are damaged to ensure a proper fit

Cast iron grate that sits over the range burner to support cookware during cooking. Replace if warped, cracked, broken, or coating is chipping off.

Wire harness for gas ranges. Connects electrical components inside your range. Replace if wires are frayed, damaged, or connections are loose or broken.

Replace your range's wire harness if the existing wiring is damaged, frayed, or showing signs of wear. Connects electrical components inside your range.

Fix unresponsive side panel buttons on your range with this control circuit board. Restores button input function and command relay to main controls.

Fix range not starting, intermittent power, or unresponsive controls with this main power control board assembly. Restores reliable electronic operation.

Insulation component that protects internal range wiring and components from heat. Replace if cracked, deteriorated, or missing to restore proper insulation.

This is the exterior side panel that attaches to the body of the range. It provides structural support and a finished appearance to the side of the appliance. Replace this panel if it is dented, scratched, rusted, or damaged during installation or use.

This is a replacement pipe used in the appliance's water/ice system to route water between components and maintain proper water flow. Replacing a damaged pipe restores reliable water delivery and helps prevent leaks. What it does:

• Carries water between the inlet, dispenser, and/or ice maker components
• Stops or reduces leaks when a cracked or corroded pipe is replaced
• Helps restore normal water flow if an internal blockage or break caused reduced dispensing
• Maintains proper routing to prevent kinks or stress on fittings

• Turn off the appliance power and shut off the household water supply before starting.
• Remove only the damaged pipe and install the matching replacement; use the same routing and fittings.
• Tighten fittings to manufacturer torque guidance and check all connections for leaks after restoring water.

Base plate for electric and gas ranges. Provides structural support at the bottom of the appliance. Replace if cracked, broken, or missing. Easy install.