Lg Wall Oven LSC5683WW Parts

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

This is a packing gasket that seals the oven door to the range cabinet, preventing heat from escaping during cooking. It is made of a flexible, heat-resistant material that lines the perimeter of the oven door. Replace this gasket if you notice excessive heat escaping from around the door, uneven cooking temperatures, or if the gasket is visibly worn, torn, or hardened.

This is a circular wire harness holder that secures and organizes internal wiring within the range. It clips onto the frame or mounting points to keep wires routed properly and away from heat sources. Replace this part if it is broken or missing, which can cause loose wiring or potential contact with hot surfaces.

This 4.0x16mm tapping screw secures trim, panels, and brackets on ranges and microwaves. Replace missing, stripped, or damaged screws during repair.

The range packing seal creates an airtight barrier around oven doors or other range components to maintain proper cooking temperatures and prevent heat loss. Positioned around door edges or component joints, it needs replacement if heat escapes, cooking becomes uneven, or the seal appears cracked or compressed.

Replacement mounting screw for electric and gas ranges. Secures components and panels. Needed when original screw is stripped, missing, or damaged.

Structural support bracket that holds and stabilizes internal range components. Replace if cracked, broken, or missing to restore proper alignment.

Replace a damaged or corroded range wiring harness that connects electrical components. Needed when the original harness is frayed, melted, or broken.

This power control board assembly regulates power and coordinates operation of the appliance's functions, restoring control to electrical and user-interface components. Replacing a faulty board can resolve intermittent power and control problems. What it does:

• Distributes power to motors, displays and sensors to enable normal operation
• Interprets user inputs and sends control signals to cycle components
• Commonly linked to symptoms like no power, unresponsive controls or erratic operation
• Can cause display errors, failure to start, or appliances that stop mid-cycle

• Disconnect the appliance from power before service to avoid shock or damage
• Handle the board by edges and avoid electrostatic discharge (ESD); ground yourself
• Verify the part number on the original board before ordering and match connectors carefully

Replace a faulty range power control board if your oven won't heat, displays error codes, or has unresponsive controls. Moderate difficulty repair.

Catches drips, crumbs and grease during cooking to protect your oven floor and simplify cleanup. Replace if warped, rusted or missing. Confirm fit with your model.

This front control panel replaces the damaged or unresponsive user interface on your appliance, restoring button and display access for normal operation. It mounts on the appliance exterior and connects to the internal control assembly. What it does:

• Provides the primary button and display area used to start cycles and select settings
• Replaces cracked, scratched, or otherwise damaged front panel surfaces
• Restores response when physical buttons or touch areas are worn or nonfunctional
• Helps eliminate erratic or missing readouts when the panel housing is the source of the issue

• Disconnect power (unplug or switch off circuit breaker) before starting any repair
• Handle the panel carefully to avoid glass or plastic damage and protect attached wiring
• Remove trim and mounting screws to access connectors; note connector positions before disconnecting
• Test the main control board and wiring harness for faults