Lg Microwave MH1517CV Parts

Microwave overheating or shutting off unexpectedly? This thermostat regulates temperature to prevent damage. A straightforward fix for most DIYers.

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

A flat washer used with the appliance's fastening hardware to distribute load and reduce wear. Helps maintain secure connections and prevents damage to mating surfaces for reliable operation. What it does:

• Provides an even bearing surface for bolts or screws to prevent pull-through
• Reduces friction and wear between fasteners and housing parts
• Helps keep fasteners tight and resists loosening from vibration
• Commonly used where a smooth, protective spacer is needed

• Verify correct location and orientation before reassembly
• Use manufacturer-recommended fasteners and torque specifications
• Power off and unplug the appliance before accessing internal components

Mounting screw for ovens, ranges, and microwaves. Secures panels, brackets, and internal components. Replace if stripped, missing, or damaged.

Fix weak or noisy ventilation with this microwave blower fan. Restores proper airflow when exhaust isn't working. Moderate DIY repair in 30-45 minutes.

This is a wire holder clip used inside a microwave to secure and route internal wiring. It keeps wires organized and safely positioned away from heat sources and moving components. Replace this holder if it is broken or missing, which can allow wires to hang loose and potentially contact hot surfaces or interfere with other parts.

This heater sheath is the metal housing that surrounds and protects the dryer's electric heating element, helping direct heated air into the drum for normal drying. Replaces a damaged or corroded sheath to restore safe, efficient heating. What it does

• Holds and shields the heating element assembly to prevent contact with other components
• Directs airflow around the heating element so the dryer can produce warm air
• Helps maintain proper element alignment and electrical insulation
• Common symptom: dryer runs but produces little or no heat
• Common symptom: visible damage, rust, or burn marks on the element housing

• One heater sheath (heating element housing) as shown

• Disconnect power (unplug or switch off breaker) before servicing to avoid electric shock
• Handle the heating element and terminals carefully; sharp edges may be present
• Inspect element, thermal fuse, and wiring while the cabinet is open; replace only confirmed faulty parts