Lg Microwave MS-2344B Parts

Microwave overheating or shutting off unexpectedly? This thermostat regulates temperature to prevent damage. A straightforward fix for most DIYers.

Replace worn, cracked, or missing door seal tape on your microwave. This adhesive strip installs around the door frame to maintain proper sealing.

Replacement cover for your microwave. Installs to protect internal components or conceal wiring. Order a new one if yours is cracked, broken, or missing.

This out case (U-bending) is the molded housing piece that secures and routes the U-shaped tubing or conduit on the appliance, helping maintain proper alignment and protection from wear. It restores correct routing and support for affected assemblies. What it does:

• Holds and guides the U-bend tubing/conduit to prevent kinks and rubbing
• Protects tubing from vibration and contact damage during operation
• Helps maintain proper routing for consistent fluid/air flow
• Common symptom: visible tubing wear, rubbing, or misalignment near the U-bend
• Common symptom: noise or vibration traced to loose or displaced tubing

• One out case (U-bending) as shown

• Power off and disconnect the appliance before servicing to avoid electrical shock
• Inspect adjacent tubing and fasteners; replace any damaged clips or seals as needed
• Tighten fasteners to OEM guidance and verify tubing is correctly seated in the new case

This turntable roller ring sits beneath the glass tray and provides a smooth rolling track so the tray rotates consistently during cooking. Replacing a worn or cracked ring restores steady rotation for even heating and quieter operation.

• Supports the glass turntable and allows it to roll around the center drive
• Helps maintain smooth, level rotation for uniform cooking results
• Wear or damage can cause the tray to stop turning, bind, wobble, or make grinding noises
• Visible cracks, flat spots, or missing/damaged rollers indicate the ring should be replaced

• Disconnect power to the microwave before servicing
• Open the door, remove the glass tray, and lift out the old ring; clean the track area
• Place the new ring in the track with rollers facing down; reinstall the tray on the coupler
• Run a brief test cycle to ensure smooth, stable rotation

A protective plastic or resin shield that covers the microwave's waveguide or other internal components from food splatter and damage. Located on the interior ceiling or side wall of the microwave, it should be replaced if cracked, burned, melted, or shows signs of arcing damage.