Lg Microwave MVH140E Parts

Secures interior panels and components. Replace when stripped, corroded, or missing to stop rattles and secure loose trim. Verify fit with your model number.

This is a replacement screw used to secure appliance components and panels. It restores proper fastening where a stripped, missing, or damaged screw causes loose parts or rattling. What it does:

• Fastens panels, trim, or internal components to maintain structural fit
• Helps stop vibration-related noise from loose assemblies
• Replaces missing or corroded screws that prevent proper closures
• Restores secure mounting after repairs or disassembly

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not over-torque to prevent thread damage
• Keep small parts away from children and pets
• Disconnect power or water before accessing internal parts

Mounting screw for microwave installation and panel assembly. Replace if stripped, missing, or damaged during maintenance. Essential hardware component.

This time delay fuse protects the appliance from overheating by opening the circuit when temperatures exceed safe limits. It's a direct-replacement electrical safety fuse used in heating circuits to help prevent damage and fire risk. What it does:

• Opens the circuit when the detected temperature rises above safe operating limits to stop the heating element
• Helps prevent overheating-related damage to internal components and wiring
• Can cause intermittent or no heating when failed
• Commonly associated with symptoms such as no heat, reduced or inconsistent heating, or a unit that stops running during heating cycles

• Disconnect power to the appliance before accessing or replacing the fuse to avoid electrical shock
• Locate the fuse according to your appliance's service manual or diagram and replace with the exact part number
• If the fuse is blown, inspect heating element, thermostat/thermal cutouts, and venting for underlying faults before reinstalling

Factory mounting screw secures panels, brackets, and internal components in microwaves. Replace missing, stripped, or corroded screws to keep assemblies tight.

This is a wire holder clip used inside a microwave to secure and route internal wiring. It keeps wires organized and safely positioned away from heat sources and moving components. Replace this holder if it is broken or missing, which can allow wires to hang loose and potentially contact hot surfaces or interfere with other parts.