Lg Range V271PM Parts

This fixed cement resistor is a durable through-hole resistor used in appliance control circuits to limit current and stabilize voltage, helping electronics run safely and reliably. What it does:

• Provides a fixed resistance value in control and power circuits to limit current flow
• Helps protect sensitive components from current spikes and contributes to stable operation
• A failed or burned resistor can cause loss of function, intermittent operation, or blown fuses
• Commonly mounted on control boards or chassis where higher power dissipation is required

• One fixed cement resistor as shown

• Disconnect power and unplug the appliance before attempting service
• Discharge capacitors and wait for components to cool before handling the board
• Replace with the exact resistance and wattage specification; do not substitute without verification

This bipolar transistor is a direct-replacement switching transistor used on control boards to help regulate and switch low-voltage currents. Replacing a failed transistor restores reliable circuit switching for affected appliance functions. What it does

• Acts as a semiconductor switch or amplifier on control electronics to enable or interrupt current flow.
• Commonly used to drive motors, solenoids, relays, or other control circuits on the board.
• Failures may cause no power to a circuit, intermittent operation, or related electronic error codes.
• Works as part of the control board's power-management and signal-routing functions.

• One bipolar transistor.

• Disconnect all power to the appliance before attempting any repair to avoid shock or damage.
• Handle the transistor and circuit board with ESD precautions; avoid touching component leads.
• Soldering/desoldering skills are typically required.

This replacement pack contains bipolar transistors used on control and power boards to switch and amplify low-voltage signals. Replacing failed transistors restores reliable switching and board operation. What it does

• Acts as a semiconductor switch and amplifier on control/power circuits
• Can stop intermittent or non-functioning board outputs when failed
• Addresses symptoms such as loss of function, intermittent operation, or electrical faults tied to a control board
• Works with PCB-mounted circuits that require matched bipolar transistor replacements

• Board-level replacement only; remove power and discharge capacitors before service
• Use proper ESD precautions and soldering skills
• Verify transistor orientation and board markings before soldering

This shaft provides a secure mounting point for the dryer drum so it turns smoothly and stays aligned. Replacing a worn shaft restores even drum rotation and reduces noise and scraping during operation. What it does

• Supports the drum at the rear and lets it rotate on the rear bearing or glide
• Keeps the drum aligned to prevent rubbing, dragging, and uneven wear
• Helps eliminate squealing, grinding, or scraping noises caused by a worn or bent shaft
• Works with the drum bearing/bushing and support assembly to maintain smooth operation

• One replacement shaft

• Disconnect power before beginning any repair; the appliance is fully de-energized
• Access typically requires removing the dryer cabinet and drum; support the drum during removal
• Inspect bearings, bushings, and seals while replacing the shaft and replace any worn parts
• Use appropriate hand tools and follow OEM service manual steps