Lg Washer WT1485CW Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Washer won't drain or shows OE error? This drain pump assembly removes water during spin cycle. Moderate DIY repair with video guide available.

Hardware washer that sits beneath screws or nuts to distribute load and secure fasteners. Replace if bent, missing, or worn to restore proper fit.

This part is a hinge. This is a genuine OEM part made by LG and has been sourced directly from the manufacturer. This part is intended to replace a broken or defective hinge on multiple different models of LG washers and dryers. This part is made for use with LG appliances and may not correctly fit appliances manufactured by other brands. This hinge is for attaching the lid of the washer or dryer to the appliance, allowing it to open and close smoothly. If the lid will not open properly, the hinge may need to be replaced. Please follow appropriate safety precautions when attempting to replace any appliance parts. Ensure the washer or dryer is fully disconnected from its power source before attempting this repair. For more accurate information on how and where to install this replacement hinge, the manufacturer owner's manual and diagrams should be referenced.As an authentic replacement part, this hinge is suitable for use on several different models of washers and dryers manufactured by LG. Please note that this is a genuine part made of high-quality, durable plastic and is sold individually.

This rubber fill hose connects the household hot water supply valve to the washing machine's water inlet valve. It delivers hot water into the wash tub during the fill cycle. Replace this hose if it is cracked, leaking, bulging, or showing signs of deterioration to prevent water damage.

Secures washer components in place. Replace if loose, broken, or missing to prevent rattling and part displacement. Verify fit with your model number.

This is the internal fill hose that connects the water inlet valve to the wash tub inside the washing machine, delivering cold water during the fill cycle. It is a rubber or reinforced hose with fittings on each end. Replace this hose if you notice leaking underneath or behind the washer, or if the machine is not filling properly with water.

Decorative screw cap that covers exposed screw heads or mounting holes on your washer. Replace if missing, cracked, or discolored to restore a clean finish.

Fix washer wobbling, noise, and uneven agitation with this pulsator cam assembly. Secures pulsator to transmission for stable rotation and reliable wash performance.

Fix a washer that won't drain or leaves standing water. This drain pump motor assembly removes water during drain cycles. Moderate DIY repair.

Replace your washer pulsator assembly if clothes aren't agitating properly or cleaning unevenly. This agitator component moves clothes during wash cycles.

This V belt is the replacement drive belt that turns the dryer drum so clothes tumble and dry evenly. It restores reliable drum rotation and helps eliminate slipping or noisy operation. What it does:

• Transfers motor power to the drum so the drum rotates during the dry cycle
• Commonly fails after wear, causing slipping or the drum not to turn
• Worn or glazed belts can cause squealing or a burning-rubber smell
• Replacing the belt restores proper tension and consistent tumbling

• One replacement V belt

• Disconnect power (and gas supply for gas dryers) before starting any work
• Access the belt by removing the dryer front or top panel per your model's service manual
• Route the belt around the drum and idler pulley, then reattach motor pulley; ensure correct alignment and tension
• Inspect rollers, idler, and motor shaft for wear and replace worn components to prevent premature belt failure