Samsung Wall Oven DOC30M977DS Parts

Tapping screw for securing range components and panels. Replace if screw is stripped, missing, or no longer holds parts securely in place.

Secures the noise filter in your wall oven to reduce vibrations and operational sounds. Replace if loose or damaged. Verify fit with your model number.

This back cover is the exterior glass panel that finishes and protects the oven/microwave rear housing while preserving the appliance's appearance. It replaces a cracked, scratched or missing rear glass cover to restore fit and finish. What it does

• Protects internal components by covering the appliance rear and helping keep debris out
• Restores the appliance's finished appearance after damage to the rear panel
• Replaces warped, cracked or chipped back glass that can interfere with proper sealing
• Serves as the mounting surface for adjacent trim and hardware where applicable

• High-level replacement only; remove power and follow manufacturer's service manual before starting
• Handle glass with care and wear cut-resistant gloves and eye protection
• Inspect mounting clips and screws; replace any damaged hardware

This replacement door gasket seals the oven door to help retain heat and maintain consistent cooking performance. It restores the oven seal to reduce heat loss and prevent smoke or odors from escaping during use. What it does:

• Creates a tight seal between the oven door and cavity to help maintain set temperatures
• Helps reduce heat loss that can cause longer cook times or uneven baking
• Limits smoke, odors and grease from escaping the oven during operation
• Reduces energy waste caused by a worn or damaged seal

• One door gasket (black) as shown

• Disconnect power and allow the oven to cool completely before starting work
• Remove the oven door or open as directed by the OEM instructions to access the gasket channel
• Press the gasket into the channel, starting at one corner and working around; replace retaining clips or screws if applicable
• Inspect the seal for proper seating and fit before returning the oven to service

Microwave not heating evenly or overheating? This thermistor assembly monitors temperature for proper cooking. Fixes inaccurate heat control issues.

Replace your damaged or missing wall oven broiler tray assembly. This tray sits in the upper cavity for broiling meats and vegetables at high heat.

Secures internal panels and components in combi ovens. Replace if bracket is bent, cracked, or broken to restore proper alignment and stability.

This is a low-profile wire rack designed to sit inside a microwave oven, providing an elevated surface for heating food or allowing multiple items to be warmed at once. The rack distributes microwave energy more evenly around dishes placed on it. Replace this rack if it is bent, has broken or missing feet, or shows signs of arcing or rust.

Seals your wall oven door to prevent heat loss and maintain cooking efficiency. Replace if you notice uneven cooking or heat escaping. Verify fit with your model number before ordering.

This is a silicone rubber seal that fits around the oven door to prevent moisture and steam from escaping during cooking, particularly in steam-clean or steam-cook modes. It sits along the door perimeter and creates a watertight barrier. Replace this seal if you notice water leaking from the oven door, steam escaping during operation, or if the rubber has become hardened, torn, or warped.

Oven fan not working or running intermittently? This motor wire harness assembly restores electrical connections between the motor and control system.