Samsung Range DOP48M86DLM Parts

This service panel is a replacement sheet-metal cover used to restore the cabinet or enclosure where internal components are accessed, protecting parts and helping maintain the appliance's original appearance. What it does

• Covers and protects internal components from dust, debris and accidental contact
• Restores a damaged, rusted or missing exterior panel for a finished look
• Resists corrosion with 20-gauge galvanized steel construction
• Provides a sturdy surface for mounting or fastening other trim or components

• One service panel (20 ga galvanized, 48" x 96")

• Disconnect power and empty the appliance area before beginning work
• Typical installation requires basic hand tools; fasteners or trim pieces
• Handle edges carefully; wear gloves to avoid cuts from sharp sheet-metal edges
• If holes or trims must be modified, use appropriate metal tools and follow safety precautions

This service nut retainer secures 1/4-20 service nuts used on panels and assemblies, keeping fasteners locked in place so parts stay aligned during use and maintenance. It's a low-profile clip designed for reliable holding where a captive nut is required. What it does:

• Captures and holds a 1/4-20 nut to provide a captive fastening point
• Keeps panels, brackets or components aligned while fasteners are installed
• Prevents nuts from falling into hard-to-reach areas during repair
• Helps reduce vibration looseness on secured assemblies

• Verify correct orientation and nut size (1/4-20) before installation
• Install with power off and disconnect appliance from power source
• May require basic hand tools; avoid forcing the retainer to prevent damage
• If hardware or mating clips are corroded or damaged, replace them together for best fit

This left-side burner support is the service assembly that holds and supports the cooktop burner components for proper operation and stable flame control. Replaces a worn or damaged burner support to restore safe cooking performance. What it does:

• Supports and positions the left cooktop burner head and related parts for correct burner alignment.
• Helps maintain stable burner operation and even flame distribution when functioning properly.
• Commonly replaced when the burner support is cracked, warped, or no longer secures burner components.
• Works with the cooktop burner assembly to prevent misalignment and potential gas/heat issues.

• 1 left burner support assembly

• Turn off gas and electricity to the appliance before beginning any service.
• Remove the cooktop or burner trim as required to access and replace the support; keep track of screws and small parts.
• Inspect nearby components (burner head, cap, igniter) for damage when replacing the support.

This manifold assembly controls and routes gas to the cooktop/oven burners, restoring proper fuel flow and safe ignition. It's a direct-fit service part designed to replace a damaged or leaking gas manifold on compatible ranges. What it does:

• Routes and distributes natural gas to the appliance's burner valves for consistent burner operation
• Stops gas flow when damaged or leaking, which can cause weak flames, burner failure, or a gas smell
• Restores proper pressure balance and ignition reliability when the manifold is the diagnosed fault

• One manifold assembly

• Intended for experienced DIYers familiar with gas appliance service
• Always shut off the gas supply and power before beginning work; verify no leaks after installation
• Use appropriate seals and torque values per OEM instructions; replace any gaskets or fittings that show wear