Samsung Range DOP48M96DPS Parts

This service cable clamp secures a refrigerator/freezer wire harness to the cabinet, reducing strain and preventing chafing for reliable electrical connections and quieter operation. What it does:

• Holds the service or harness cable firmly to the cabinet or chassis to prevent movement
• Reduces strain on wire terminals to help avoid intermittent connections
• Helps prevent wire chafing and insulation wear that can lead to shorts
• Keeps wiring neat and routed away from moving parts or hot surfaces

• Always unplug the appliance or disconnect power at the breaker before beginning any work
• Remove any access panels needed to reach the original clamp location; install by aligning with the original mounting point and securing using the original method
• Position the cable in the clamp so it is held snugly without pinching the insulation
• After installation, restore power and inspect for any loose wires

This service ring is the OEM replacement burner ring that restores proper burner alignment and supports even flame distribution for gas cooktop/range burners. It helps return the burner to safe, reliable operation after wear or damage. What it does:

• Centers and supports the burner cap and ports for consistent flame pattern
• Helps prevent uneven heating or unstable flames caused by warped or damaged rings
• Fits into the burner assembly to maintain correct spacing and alignment
• Useful when the original ring is cracked, bent, or otherwise visibly damaged

• Shut off gas supply and power to the appliance before attempting service
• Remove burner cap and grate, then lift out the old ring; install the new ring seated flat and aligned with burner ports
• Inspect burner ports and cap for debris before reassembly; clean with a soft brush if needed

This reducer bushing helps center and support the dryer drum drive reducer so the drum turns smoothly and quietly. It replaces worn or damaged bushings to reduce rubbing, squeaks, and uneven drum movement. What it does:

• Supports the drive reducer to keep the drum aligned during operation
• Reduces metal-on-metal contact that can cause squeaks or grinding noises
• Helps prevent uneven drum rotation and premature wear on adjacent parts
• Commonly replaced when you hear noise or notice rough drum movement

• Disconnect power before beginning any repair to avoid shock or injury
• Access may require removing the dryer front or rear panel
• Inspect the reducer and surrounding components; replace any damaged parts found
• Do not force parts into place; if resistance is excessive, verify alignment and part orientation