Samsung Cooktop DTG36M955FS Parts

This main wire harness routes power and control signals between a dryer's primary components, restoring electrical connectivity so the appliance can receive power and respond to controls. Designed as a direct-fit replacement for the factory harness. What it does:

• Carries 120 VAC power and signal connections between the control board, motor, heater, and other primary components
• Replaces damaged, frayed, or corroded wiring that can cause no-power, intermittent operation, or failed cycles
• Ensures secure plug-and-play connections with factory-style terminals and connector plugs
• Helps eliminate arcing, shorts, or open circuits caused by broken harness wiring

• One main wire harness assembly (120 VAC) as pictured

• Disconnect all power (unplug or shut off breaker) before beginning any repair
• Handle connectors gently; align terminals fully and lock any retaining clips to prevent loose connections
• Route harness along factory clips/channels and secure with original fasteners to avoid heat or pinch damage

No broil heat or uneven browning? Replace your failed upper broil element to restore intense radiant heat for proper broiling. DIY-friendly repair.

Burner won't ignite or clicks continuously? This dual electrode assembly restores spark ignition on gas cooktops. Moderate DIY repair for most models.

Wine cooler has no power, no lights, or display not working? This transformer supplies power to the control board. Simple electrical repair for DIYers.

Fix uneven flames or burners not igniting properly with this orifice holder. Secures gas orifice for proper fuel flow. Simple installation in 15 minutes.

Replace your worn cooktop burner gasket to restore a proper seal and prevent gas leaks. Essential for safe operation. Verify fit with your model number.

This burner head assembly replaces a damaged or worn mid-right gas burner head to restore proper gas flow and flame pattern on compatible ranges. It fits into the cooktop to deliver an even, controlled flame for cooking. What it does:

• Directs gas from the valve to the burner ports so the cooktop produces a consistent flame
• Helps restore even heating when a burner has weak or irregular flames
• Can stop symptoms such as a burner that won't light reliably, produces yellow/sooty flames, or has uneven heating
• Works with the existing burner cap and cooktop components when the correct assembly is installed

• One mid-right burner head assembly

• Turn off the gas supply and disconnect power to the appliance before beginning work
• Remove grates and burner caps, then lift out the old burner head and seat the replacement securely
• Check for proper alignment with the burner valve and ignition electrode; reassemble grates and test for correct ignition and flame pattern

Can't connect your cooktop to your smartphone or smart home system? This bluetooth module restores wireless connectivity for remote control and monitoring.