Samsung Cooktop DTG36M955FS Parts

This tube assembly routes wash water to the dishwasher's right-front spray area to restore proper water distribution for effective cleaning. It replaces a damaged, cracked, or clogged right-front supply tube. What it does:

• Directs wash water to the right-front spray arm/nozzle for proper cleaning coverage
• Restores normal spray patterns when the original tube is cracked, split, or blocked
• Helps prevent internal leaks caused by damaged tubing or failed connections
• Supports the dishwasher's circulation system to maintain rinse and wash performance

• Disconnect power and shut off the water supply before starting any repair
• Remove the door or access panel as needed to reach the tube; retain mounting clips and fasteners
• Inspect adjoining seals and fittings; replace any damaged grommets or clamps for a watertight fit

This right-rear assembly tube routes and delivers water inside the dishwasher to ensure proper circulation and drainage where designed. Replacing a damaged tube restores normal water flow and helps stop leaks or pooling. What it does:

• Channels water to/from the dishwasher's right-rear area as part of the internal plumbing.
• Prevents leaks and maintains correct water routing when intact.
• Commonly replaces tubes that are cracked, split, or blocked and causing pooling or poor wash performance.
• Can resolve related error conditions tied to improper water flow or drainage.

• One right-rear assembly tube

• Disconnect power and shut off the water supply before beginning any repair.
• Inspect adjoining seals, clamps, and fittings and replace any worn components for a secure, leak-free connection.
• Handle plastic fittings gently to avoid cracking; tighten hose clamps just until snug—do not overtighten.
• After installation, restore power and water, then run a short cycle while checking carefully for leaks.

This ignition switch assembly operates the spark ignition for a gas range burner, allowing the burner to light reliably when the control is turned. It replaces a worn or damaged switch to restore normal ignition operation. What it does:

• Sends the electrical spark to the burner valve when the range control is actuated
• Stops clicking or failed ignition when the switch no longer produces spark
• Prevents intermittent or no-ignition symptoms caused by a faulty control switch
• Works as the user-facing actuator that enables burner lighting from the control panel

• One ignition switch assembly

• Disconnect electrical power and shut off the gas supply before starting work
• Access typically requires removing the cooktop or control panel; keep track of mounting hardware
• Handle the switch and wiring gently to avoid damage; recheck connections before restoring power and gas

This main wire harness routes power and control signals between a dryer's primary components, restoring electrical connectivity so the appliance can receive power and respond to controls. Designed as a direct-fit replacement for the factory harness. What it does:

• Carries 120 VAC power and signal connections between the control board, motor, heater, and other primary components
• Replaces damaged, frayed, or corroded wiring that can cause no-power, intermittent operation, or failed cycles
• Ensures secure plug-and-play connections with factory-style terminals and connector plugs
• Helps eliminate arcing, shorts, or open circuits caused by broken harness wiring

• One main wire harness assembly (120 VAC) as pictured

• Disconnect all power (unplug or shut off breaker) before beginning any repair
• Handle connectors gently; align terminals fully and lock any retaining clips to prevent loose connections
• Route harness along factory clips/channels and secure with original fasteners to avoid heat or pinch damage