Samsung Range HDPR36S Parts

This service ring is the OEM replacement burner ring that restores proper burner alignment and supports even flame distribution for gas cooktop/range burners. It helps return the burner to safe, reliable operation after wear or damage. What it does:

• Centers and supports the burner cap and ports for consistent flame pattern
• Helps prevent uneven heating or unstable flames caused by warped or damaged rings
• Fits into the burner assembly to maintain correct spacing and alignment
• Useful when the original ring is cracked, bent, or otherwise visibly damaged

• Shut off gas supply and power to the appliance before attempting service
• Remove burner cap and grate, then lift out the old ring; install the new ring seated flat and aligned with burner ports
• Inspect burner ports and cap for debris before reassembly; clean with a soft brush if needed

This reducer bushing helps center and support the dryer drum drive reducer so the drum turns smoothly and quietly. It replaces worn or damaged bushings to reduce rubbing, squeaks, and uneven drum movement. What it does:

• Supports the drive reducer to keep the drum aligned during operation
• Reduces metal-on-metal contact that can cause squeaks or grinding noises
• Helps prevent uneven drum rotation and premature wear on adjacent parts
• Commonly replaced when you hear noise or notice rough drum movement

• Disconnect power before beginning any repair to avoid shock or injury
• Access may require removing the dryer front or rear panel
• Inspect the reducer and surrounding components; replace any damaged parts found
• Do not force parts into place; if resistance is excessive, verify alignment and part orientation

This lower service-mount kick panel replaces the dryer's front lower access cover to restore a finished appearance and protect internal components from dust and debris. It's a direct-fit service panel used during repair or maintenance. What it does:

• Covers and protects blower, wiring and other lower cabinet components from damage and lint buildup
• Provides the finished lower-front appearance and helps keep warm air and lint contained
• Replaces cracked, bent or missing lower access panels that cause gaps or rubbing
• Helps stop rattling or vibration caused by loose or damaged lower trim

• Disconnect power (and gas if applicable) before accessing internal components
• Removal/installation typically requires basic hand tools; support the panel to avoid dropping
• Watch for sharp sheet-metal edges and wear gloves to protect hands