Samsung Range HDPR36S Parts

This left-hand end cap enclosure is the outer housing piece that secures and protects components at the end of the assembly, keeping wiring and internal parts contained and aligned for reliable operation. What it does:

• Covers and protects the end of the assembly from dust, debris and incidental contact
• Holds wiring and internal components in place to prevent snagging or movement
• Restores correct alignment and mounting when a cracked or broken cap causes looseness
• Helps reduce noise and vibration from exposed or loose end components

• One left-hand end cap enclosure

• Disconnect power to the appliance before beginning any repair
• Inspect adjoining covers and fasteners; replace any damaged clips or screws for a secure fit
• Use basic hand tools; avoid forcing parts to prevent cracking the new enclosure

This service extrusion enclosure replaces a damaged or worn rear enclosure to protect internal components and restore the appliance's cabinet fit. It keeps wiring and parts covered for safe, reliable operation. What it does

• Replaces the rear extrusion enclosure to restore proper rear-panel coverage and alignment
• Shields internal wiring and components from debris and accidental contact
• Helps stop rattles or gaps caused by a cracked or misshapen rear enclosure
• Supports correct mounting of adjacent panels and seals

• Disconnect power before starting any repair to avoid shock or injury
• Typical installation requires removing rear access panels and unscrewing fasteners; keep hardware for reuse
• Handle edges carefully to avoid cuts and prevent damage to clips or mounting tabs
• If clips or adjacent trim are damaged, inspect and replace as needed for a secure fit

This welded glass frame for the broiler door replaces a damaged or worn frame to restore the door's appearance and help the broiler seal and operate as intended. Fits into the broiler door assembly and supports the broiler glass. What it does:

• Replaces a cracked, warped, or separated broiler glass frame that can let heat escape or expose sharp edges
• Supports and secures the broiler glass panel inside the oven door assembly
• Restores proper alignment of the broiler glass for safer operation and better heat containment
• Helps prevent rattling or movement of the broiler glass during use

• One welded broiler glass frame

• Disconnect power and allow the appliance to cool completely before starting
• Handle glass edges carefully; wear protective gloves and eye protection
• Installation typically requires removing the broiler/oven door or door inner panel to access the frame

This convection baffle directs hot air in the oven cavity for more even cooking and protects internal components from direct heat. Replacing a cracked or warped baffle restores proper airflow and helps reduce uneven baking. What it does:

• Redirects convection airflow to promote consistent oven temperature distribution
• Shields oven back components from direct heat
• Prevents rattling or vibration caused by a loose or broken baffle
• Helps correct symptoms like uneven baking, hot spots, or visible damage to the baffle

• One black convection baffle

• Disconnect power to the appliance and allow the oven to fully cool before servicing
• May require removal of oven panels or racks; basic hand tools are typically needed
• Handle part carefully to avoid damage; follow the appliance service manual for step-by-step instructions