Samsung Range HDPR48C Parts

Felt wiper strip seals and cleans your vent system's moving components. Replace when worn, compressed, or no longer creating an effective seal. Verify fit with your model number before ordering.

This is an LP (liquid propane) gas regulator assembly that controls the pressure of propane fuel supplied to the burners. It ensures a consistent and safe gas flow from the supply line to the appliance. Replace this regulator if you experience uneven flame, yellow or weak burner flames, gas odor near the connection, or if the range has been converted to LP and the existing regulator is damaged or incompatible.

This service nut retainer secures 1/4-20 service nuts used on panels and assemblies, keeping fasteners locked in place so parts stay aligned during use and maintenance. It's a low-profile clip designed for reliable holding where a captive nut is required. What it does:

• Captures and holds a 1/4-20 nut to provide a captive fastening point
• Keeps panels, brackets or components aligned while fasteners are installed
• Prevents nuts from falling into hard-to-reach areas during repair
• Helps reduce vibration looseness on secured assemblies

• Verify correct orientation and nut size (1/4-20) before installation
• Install with power off and disconnect appliance from power source
• May require basic hand tools; avoid forcing the retainer to prevent damage
• If hardware or mating clips are corroded or damaged, replace them together for best fit

This convection baffle directs hot air in the oven cavity for more even cooking and protects internal components from direct heat. Replacing a cracked or warped baffle restores proper airflow and helps reduce uneven baking. What it does:

• Redirects convection airflow to promote consistent oven temperature distribution
• Shields oven back components from direct heat
• Prevents rattling or vibration caused by a loose or broken baffle
• Helps correct symptoms like uneven baking, hot spots, or visible damage to the baffle

• One black convection baffle

• Disconnect power to the appliance and allow the oven to fully cool before servicing
• May require removal of oven panels or racks; basic hand tools are typically needed
• Handle part carefully to avoid damage; follow the appliance service manual for step-by-step instructions