Samsung Washer SWT50B1DW Parts

This electrical harness connector joins wiring to a component or control, restoring a secure electrical connection so circuits operate reliably. It's used where a factory-style plug/receptacle is required for power or signal transfer. What it does:

• Provides a secure, keyed connection between wiring and a control, sensor, or module
• Restores reliable power or signal flow when an original connector is damaged or corroded
• Helps stop intermittent operation, arcing, or poor contact caused by loose or broken terminals
• Matches factory fit and pin arrangement to maintain OEM wiring routing and function

• One replacement electrical connector

• Disconnect power (unplug appliance or shut off breaker) before inspecting or replacing connectors
• Verify connector orientation and pin count match the original before installation
• Do not force terminals; ensure full engagement and that any locking tab snaps into place
• If wiring or terminals are burned or corroded, replace or repair the wiring harness as needed

This connector is a small wire-harness mating piece that secures electrical leads and maintains reliable power/signal flow inside the appliance. It replaces a damaged or loose connector to restore proper electrical connections. What it does:

• Joins wire harnesses or wires so circuits receive power and signals reliably
• Provides a secure, friction-fit electrical connection to prevent intermittent contacts
• Commonly replaced when wiring is frayed, terminals are corroded, or the connector housing is cracked
• Can help stop symptoms like intermittent operation, failure to start, or erratic electrical behavior

• Disconnect power and, if applicable, gas supply before servicing
• Inspect mating terminals and harness for damage; replace wiring or terminals if necessary
• Ensure connector is fully seated and locked into place to avoid loose contacts

This replacement drain hose restores reliable water removal from the appliance, helping prevent leaks and standing water during cycles. Designed to match the original shape and routing for a proper fit and dependable drainage. What it does:

• Carries wastewater from the tub/pump to the household drain or drain pump
• Restores proper draining to address slow draining or water left in the appliance
• Replaces cracked, split or kinked hoses that can cause leaks
• Fits the original connection points and routing to maintain normal operation

• Disconnect power and water supply before starting any repair
• Drain remaining water from the appliance to avoid spills
• Inspect clamps and fittings; replace clamps if corroded or damaged
• Ensure the hose is routed without sharp bends or kinks and is securely clamped at both ends