Samsung Washer WCVH4800K1WW Parts

With the video that was made from appliance pro.Help me out one hundred percent to understand what I was dealing with Read more

The error code implies a faulty fill valve. This was not the case for me. Replacing the main PCB assembly solved the problem. I have run two full loads since the repair with no problems. Read more

• Will not stop filling with water

Machine was a front load washer, after doing some research found that problem is usually caused by pressure sensor or the spider arm which attaches motor to tub. Read more

The start button had been tricky to use. You had to push it in just a certain way to get the dryer to start. Eventually it was non-responsive. All other controls worked and there was no error code displayed. The repair was to replace the whole control board which cost around $100. Heavy sigh.. Be sure to keep track of all your screws. BTW it was not the thermal fuse. All the online videos say this is the first thing to look for when the dryer will not start. Be sure to check with the person... Read more

At first I thought it was the bearing, but when I got it apart I found the main shaft had corroded from possibly the soap powder and bleach combo build up on the part. After I cleaned it all up I found one of the three mounting braces was cracked and causing the unit to shake during the spin cycle. Once I replaced that part and replaced a few missing parts I lost all found on your store the unit went together just as it came apart and works excellent. Read more

Part fit perfectly, great next day delivery. Read more

I was able to find a video on U-Tube that walked me thru the disassembly and reassembly of the dryer. The whole process only took an hour and at the same time I was able to vacuum out the inside of the unit . The part delivery was unbelievable fast which made the down time minimal Read more

• Won't start

First I checked the breaker and outlet and both were good...then I unplugged the machine, took the top off, and removed the control panel. I check the wiring to see if there were any loose plug ins, etc...This is where I figured the panel was bad (or possibly the power cord) so I ordered both. The parts arrived the next day. (incredibly fast shipping) Since I wasn't expecting them til after the weekend I left everything disassembled and went on a mini vacation for a couple of days. Upon... Read more

Normally, I hire someone to come fix washer or dryer problems as time is limited and if the cost is close or more than the machine, I buy a new one instead. But since we are on shelter-in-place, I figure I could repair it since I have more time on my hands and my brother assured me, it was not hard to do. I took the top panel, door off and then looked online to find a service manual, which allowed me to take the front panel off. My suspected drain hose was the failure mode: the rubber tube... Read more

Replaced the front and rear shock absorbers. Used the video help that was attached to the parts ordered screen. A great website for finding the parts needed and all the additional assistance from reviews to videos, thank you! Read more

I replaced the thirmister. Read more

I had to disassemble the barrel assembly in order to find the cause. The videos showed how to do it. I did it according to the videos, not too hard, just time consuming and labor intensive. I found the flange shaft assembly was badly cracked, allowing the barrel to shift off center and rub. I purchased the assembly, a new tub seal and a ring (there was a ring included with the assembly, so didn't really need the ring} from here. I also replaced the bearing and shaft seal, purchased locally,... Read more