Samsung Washer WF22R6270APCXD Parts

Hose that connects to the dispenser drawer in your washer. Replace if cracked, leaking, or disconnected to restore proper water flow to detergent.

Fix washer temperature error codes (tE, FE) with a new thermistor. Monitors water temperature for proper cycle operation. DIY-friendly repair with video.

Replacement door support hinge for front-load washers. Needed when the original hinge is cracked, broken, or no longer holds the door securely.

This drain hose assembly routes wastewater from the washer tub to the drain pump to help ensure proper draining and reduce the risk of leaks. It replaces a damaged, cracked or clogged drain hose so machines can empty correctly. What it does:

• Channels wastewater from the tub to the drain pump and drain line
• Restores proper draining when the original hose is cracked, split, crushed or clogged
• Helps stop leaks that occur from damaged or loose drain hose connections
• Addresses symptoms such as standing water in the drum, water under the washer, or intermittent draining

• Disconnect power to the washer before starting any work
• Turn off the water supply and place towels to catch any residual water when removing the old hose
• Remove the old hose and clamps, route the new hose the same way to avoid kinks, and secure with appropriate clamps
• After installation, restore power and run a short drain/spin cycle to check for proper operation and leaks

Fix washer not draining or slow draining issues with this brushless DC drain pump motor. Compatible with top-load washers. Moderate DIY repair.

Secures cables in your washer to prevent electrical issues and ensure reliable connections. Replace if damaged, loose, or causing wiring problems.

This filter guide holds and positions the washer's internal lint/dirt filter so the filter seals and drains correctly, helping maintain wash performance and protect the drain system. Designed to restore proper filter alignment and flow. What it does:

• Secures the filter element inside the housing so water and lint pass through the filter as intended
• Helps prevent filter misalignment that can cause poor draining or debris buildup
• Restores proper drainage path and reduces chance of filter bypass
• Compatible with factory filter assemblies that use a molded guide to position the filter

• One filter guide

• Turn off and unplug the washer and shut off the water supply before servicing
• Remove the access panel or agitator as needed to reach the filter area; follow the service manual for your model
• Inspect seal and surrounding housing for damage; replace any worn components to ensure a watertight fit

Replacement cover assembly that protects the control board (PBA) on your washer. Install if the original cover is cracked, broken, or missing.

Fix excessive vibration or spinning issues in your washer with this flange shaft assembly. Connects the drum to the drive system for smooth operation.

Drain hose assembly that connects your washer to the standpipe or drain. Replace if cracked, leaking, kinked, or damaged to restore proper drainage.

Replace a blank, unresponsive, or cracked washer display panel. This touch control module restores full operation of your washing machine's interface.

Washer not filling or draining properly? The air pressure sensor monitors water levels to control fill and drain cycles. Direct replacement part.

Plastic guide that directs detergent flow in your washer's dispenser. Replace if cracked, broken, or missing to restore proper detergent dispensing.

Connects the detergent drawer to the wash tub in front-load washers. Replace if cracked, leaking, or disconnected to restore proper water flow.

Maintains watertight seal in your washer drum. Replace if you notice leaks during wash cycles or water pooling. Verify fit with your model number.