Samsung Washer WF45R6300AP Parts

Drain hose assembly that connects your washer to the standpipe or drain. Replace if cracked, leaking, kinked, or damaged to restore proper drainage.

Fix excessive vibration or spinning issues in your washer with this flange shaft assembly. Connects the drum to the drive system for smooth operation.

Washer not filling or draining properly? The air pressure sensor monitors water levels to control fill and drain cycles. Direct replacement part.

Plastic guide that directs detergent flow in your washer's dispenser. Replace if cracked, broken, or missing to restore proper detergent dispensing.

Replace a blank, unresponsive, or cracked washer display panel. This touch control module restores full operation of your washing machine's interface.

Fix leaks or loud spinning noise with this washer outer tub back assembly. Essential for restoring drum stability and preventing water damage. Moderate DIY.

Connects the detergent drawer to the wash tub in front-load washers. Replace if cracked, leaking, or disconnected to restore proper water flow.

Protective cover assembly for washer power control panel. Replaces cracked, broken, or missing covers to shield internal controls from damage and wear.

Maintains proper water flow and pressure in your washer. Replace if you notice leaks, reduced water pressure, or visible wear on the hose. Verify fit with model.

Fix inconsistent water temperatures or incorrect cycle times with this washer thermistor packing assembly. Secures the temperature sensor for accurate readings.

Tapping screw for washers and dryers. Secures internal panels and components. Replace if stripped, missing, or damaged during repairs or maintenance.

Self-tapping screw secures dryer panels and components. Replace if stripped, missing, or damaged during service to restore proper assembly.

M10 x 124.5mm hex bolt secures internal components in your washer. Replace if bolt is stripped, missing, or damaged during repairs or maintenance.

This is a door latch mechanism that secures the refrigerator door in the closed position. It engages with the door strike to keep the door properly sealed and maintain interior temperature. Replace this latch if the door will not stay closed, pops open on its own, or the latch mechanism is visibly broken or worn.

This is a stainless steel encoder control knob that mounts on the front panel of the dryer and is used to select cycle settings. The knob incorporates an encoder mechanism that communicates your selection to the electronic control board. Replace this knob if it is cracked, loose, or no longer clicks into position properly, or if the dryer does not respond when you turn it.

Maintains watertight seal in your washer drum. Replace if you notice leaks during wash cycles or water pooling. Verify fit with your model number.