Samsung Washer WF51CG8000AVA5 Parts

This assembly hose connects the appliance's water/drain plumbing to the drawer assembly, restoring proper flow and helping prevent leaks or pooling in the drawer area. Use when a hose is cracked, clogged, or leaking. What it does

• Carries water to or from the drawer plumbing so the drawer operates correctly.
• Replaces torn, kinked, or hardened hoses that can cause leaks.
• Stops water pooling or dripping into the drawer area when replaced.
• Helps restore normal water flow and reduces risk of damage from leaks.

• Turn off power to the appliance and shut off the water supply before beginning work.
• Inspect clamps and seals; replace any worn or damaged fasteners to ensure a watertight connection.
• Route the hose without sharp kinks and secure it per the appliance's service instructions.
• After installation, restore power and water, then check for leaks during a short test run.

This S. Tub Back Assembly replaces the rear section of the washer tub to restore proper drum support and containment of wash water. It's a direct-fit tub component used when the tub shell is damaged, cracked, or leaking. What it does

• Replaces the rear/back portion of the washer tub shell to stop leaks from the drum area.
• Restores correct drum alignment and support to reduce vibration and rubbing noises caused by a damaged tub.
• Ensures the wash chamber holds water for normal washing and rinsing cycles.
• Helps prevent further damage to bearings, seals, and internal components when the tub shell is compromised.

• One S. Tub Back Assembly (rear tub section) — only the listed tub back component is included.

• Disconnect power and water supplies before starting; drain washer and remove electrical connectors to avoid shock or flooding.
• Inspect adjacent seals, bearings, and mounting hardware during replacement and replace as needed.
• Follow OEM service manual steps for alignment and secure fastener torque to prevent leaks and noise.

This semi tub assembly is the rear outer tub section that supports the wash drum and helps contain water during cycles. Replacing a damaged semi tub restores proper drum support and helps stop leaks and excessive vibration. What it does:

• Supports the inner drum and bearings for smooth spinning and balanced loads
• Forms the rear portion of the washer tub to help contain water during wash and spin
• Reduces vibration and noise when the tub and drum are properly aligned
• Can help stop leaks originating from a cracked or warped rear tub section

• Disconnect power and water supply before beginning repair
• Access requires partial disassembly of the washer cabinet and removal of the drum; have appropriate tools on hand
• Inspect seals, gaskets, bearings and mounting hardware while replacing the tub; replace any worn items
• Use care to avoid damaging the tub finish or sharp edges; follow OEM service manual steps for reassembly

Washer won't drain or leaves water standing? This drain pump assembly removes water during the drain cycle. Moderate DIY repair, typically 30-45 minutes.

Secures the washer tub during transportation and moving. Prevents damage from movement and vibration. Sold individually; most washers require 4 bolts.

Fix washer drainage issues and leaks with this drain pump filter assembly. Prevents blockages and ensures proper water flow. Moderate DIY repair.

Replacement door support hinge for front-load washers. Needed when the original hinge is cracked, broken, or no longer holds the door securely.

Washer door hinge bracket that mounts the door to the cabinet. Replace if cracked, broken, or the door sags. Ensures secure door alignment and operation.

Fix excessive washer noise and vibration during drain cycles with this pump cushion assembly. Dampens pump vibrations for quieter operation.