Samsung Washer WF520ABPXAA Parts

Keeps your washer stable and balanced. Replace if worn, damaged, or rubber base is missing to prevent walking and sliding. Verify fit with your model.

This hinge guide is the small bushing the hinge pin rides in. It reduces friction and keeps the panel aligned so the door or lid opens smoothly and closes flush for reliable everyday use.

• Provides a low-friction bearing surface for the hinge pin
• Helps maintain door/lid alignment so it closes flush
• Wear can lead to sagging, scraping, squeaking, or binding
• Restores smooth operation and consistent closing when the original is worn

• Disconnect power; shut off water supply
• Support the door or lid before loosening hinge fasteners
• Remove the worn guide and install the new guide on the hinge pin or in the hinge bracket
• Reassemble, then check alignment and smooth open/close

Secures hose connections in your washer to prevent leaks and maintain water flow. Replace if you notice drips or loose fittings. Verify fit with your model.

Securely holds your washer's drain hose in place during operation. Replace if the hanger is cracked, broken, or missing to prevent hose movement.

This is the front cover panel assembly that forms part of the washer's exterior housing. It provides structural support and a finished appearance to the front of the machine. Replace this panel if it is cracked, dented, corroded, or if mounting points are broken, causing misalignment of the door or other front-facing components.

Mounting screw for dryer assembly. Secures internal components and panels. Replace if stripped, missing, or damaged during service or repairs.

This is a rubber or plastic hose that connects the water inlet valve to the detergent or fabric softener dispenser in the washing machine. It carries water into the dispenser housing to flush soap or additives into the wash drum at the correct time during the cycle. Replace this hose if you see leaking near the dispenser area, the dispenser is not filling with water, or the hose shows cracks and deterioration.

Hex screws for dryer assembly and panel installation. Replace missing, stripped, or damaged screws during repairs or when securing components.

This is a hex bolt used to secure various components within a refrigerator. It provides structural fastening for panels, brackets, or internal assemblies. Replace this bolt if it is stripped, corroded, or missing, which can cause loose or rattling components.

Fix E3 error codes or loud scraping noises during spin with a new washer motor rotor. Common cause when magnets break loose. Moderate DIY repair.

Secures cables in your washer to prevent electrical issues and ensure reliable connections. Replace if damaged, loose, or causing wiring problems.

M6 x 56mm zinc-plated mounting bolt secures internal components in your washer. Replace if bolt is stripped, corroded, or missing during repairs.

Reduces electromagnetic interference in your washer's electrical system. Replace if the washer won't power on or experiences electrical issues.

Leg ring assembly for washers. Secures connection between the washer body and leveling legs. Replace if cracked, broken, or missing for stability.