Thermador Dishwasher DWHD44EF Parts
Genuine Bosch part
By: Bosch
Part Number: 00066400
Do-It-Yourself Stories from Customers like You
Condensation trap cap for Bosch dishwasher. Antoni G. • Potomac , MD • March 17, 2019
Possible with daily use and vibration the cap fell off and got thrown away. So every few weeks the unit wouldn't cycle and drain pump would drain continuously when turned on. So I had to pull out the unit, drain the drain pan and start the whole process over again until the next time the drain pan filled. Then I noticed what was happening.. without the cap which ( mal) screws in from the inside and seals the condensation trap against the outside wall of the cabinet water was allowed to "leak"...
Read more
More
$12.95
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00165286
$13.34
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00166627
Fix detergent door that won't open or latch properly. This dispenser plunger actuator restores mechanical engagement between the lid and release mechanism.
More
$12.95
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00169525
M6 x 26 screw secures the dishwasher door tension adjuster assembly. Replace if screw is stripped, missing, or loose to restore proper door alignment.
More
$8.81
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00171024
This dishwasher condensation hose adapter connects drainage tubing to remove moisture buildup from inside the dishwasher. It ensures proper water flow from the condensation system to prevent water accumulation in the unit. Replace this adapter if you notice water pooling in the bottom of your dishwasher, if there are leaks around the drainage area, or if the dishwasher isn't drying dishes properly.
More
$14.95
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00417498
Spring-style hose clamp secures dishwasher water and drain hoses to prevent leaks. Replace when clamps lose tension or show rust. Verify fit with model.
More
$4.45
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00416681
$5.57
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00165279
This turbidity sensor detects how clear the dishwasher's wash water is so the control can adjust cycle time, rinses, and water changes. Replacing a faulty sensor helps restore proper cleaning performance and normal cycle lengths.
- Monitors soil level/clarity of the wash water
- Signals the control to extend or shorten wash and rinse phases as needed
- Helps optimize water use while maintaining cleaning results
- Failure symptoms can include unusually long or short cycles, poor cleaning, repeated draining/refilling, or cycles that won't advance
What's included: 1 turbidity sensor assembly Install notes:
- Disconnect power and turn off the water supply before servicing
- Pull the dishwasher out as needed; access the sensor from the base area
- Place a towel to catch residual water; release the locking tab or twist-lock, unplug the connector, and install the new sensor fully seated and locked
- Restore power/water and run a test cycle; check for leaks
Do-It-Yourself Stories from Customers like You
Washing cycle was getting longer and longer Donald W. • Avon , IN • August 21, 2020
Replaced the turbidity sensor. I watched the video on how to replace the sensor. It took me a little longer than what service rep. said. But I finely finished the repair and now my wife has been using the dishwasher for the past week. I kept checking for leaks but so far so good. Thank you Appliance Parts Pros for your help. I installed the sensor on 08/18/2020. Don
Read more
More
Genuine Bosch part
By: Bosch
Part Number: 00422793