Thermador Range ME302EP Parts

Fix an oven that won't reach temperature or gradually loses heat. This bake element generates heat for cooking. Moderate DIY install with clips.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Replace a faulty wall oven transformer when your oven won't power on or displays no lights. This internal electrical component steps down voltage.

90-degree connector cable for ovens and cooktops. Replaces damaged, frayed, or missing connectors. Essential for secure electrical connections.

This spacer is a small structural component that maintains proper clearance between oven parts. Replace if broken, missing, or worn to ensure correct spacing.

Replace your wall oven's interior light bulb to restore visibility while cooking. Install when the bulb burns out or flickers. Verify fit with your model.

Wall oven not heating or displaying errors? A faulty cable harness often causes electrical failures. This internal wiring assembly typically requires 1-2 hours to replace with moderate skill.

A small chassis knockout protector that shields wiring and components where factory knockout holes are removed. Helps prevent wire abrasion and keeps openings tidy for safe appliance operation. What it does:

• Fits into a chassis knockout to protect wiring from sharp sheet-metal edges
• Helps prevent cable chafing and short circuits by covering exposed openings
• Keeps out debris while allowing routed harnesses to pass through the cabinet
• Commonly used where service or modifications require a sealed knockout

• One chassis knockout protector

• Install by pressing the protector into the knockout until it seats securely
• Ensure wiring is routed through the protector and not pinched between metal edges
• Disconnect power before servicing appliance to avoid shock or injury

This is an insert component designed for use in a range vent hood. It fits into the hood housing to support proper airflow or provide a finished appearance on the unit's exterior. Replace this insert if it is damaged, warped, or missing, which can affect the fit and function of the vent hood.