Thermador Range MEMW271EB Parts

Mounting screw for gas ranges, wall ovens, and range installations. Used to secure panels, brackets, or internal components. Replace if missing or stripped.

Restores a tight seal between your wall oven door and cabinet. Replace if worn, torn, or causing heat loss. Confirm fit by model number before ordering.

Wall oven not heating or displaying errors? A faulty cable harness often causes electrical failures. This internal wiring assembly typically requires 1-2 hours to replace with moderate skill.

A small chassis knockout protector that shields wiring and components where factory knockout holes are removed. Helps prevent wire abrasion and keeps openings tidy for safe appliance operation. What it does:

• Fits into a chassis knockout to protect wiring from sharp sheet-metal edges
• Helps prevent cable chafing and short circuits by covering exposed openings
• Keeps out debris while allowing routed harnesses to pass through the cabinet
• Commonly used where service or modifications require a sealed knockout

• One chassis knockout protector

• Install by pressing the protector into the knockout until it seats securely
• Ensure wiring is routed through the protector and not pinched between metal edges
• Disconnect power before servicing appliance to avoid shock or injury

This is an insert component designed for use in a range vent hood. It fits into the hood housing to support proper airflow or provide a finished appearance on the unit's exterior. Replace this insert if it is damaged, warped, or missing, which can affect the fit and function of the vent hood.

This service access cover protects internal components and wiring while keeping the appliance's exterior neat. It restores a clean appearance and helps prevent accidental contact with internal parts during normal use. What it does:

• Protects internal components, connectors and wiring from dust and debris
• Helps reduce risk of accidental contact with electrical parts
• Restores the appliance's finished look after repairs or maintenance
• Useful when replacing or servicing nearby components that require the cover removed

• Disconnect power (unplug or switch off circuit breaker) before starting any work
• Remove and reinstall using the factory mounting clips or screws; avoid forcing the cover to prevent breakage
• Handle plastic tabs gently—inspect tabs and mounting points for damage before final install

Flexible conduit cable that protects electrical wiring in your oven. Replaces cracked, damaged, or worn conduit. Installs between junction box and unit.

Catalyzer component for electric ovens and ranges. Installs inside the oven cavity. Order a replacement if your catalyzer is cracked, damaged, or missing.

A replacement mounting screw used to fasten appliance panels and components. Simple, direct fit when the original fastener is lost or damaged—restores secure assembly and helps prevent rattles or loose parts. What it does:

• Secures panels, brackets, or small components to the appliance frame
• Restores proper alignment and reduces vibration or noise from loose parts
• Replaces a missing, stripped, or corroded factory screw
• Used wherever the OEM lists part 00606699 as the specified fastener

• Use the matching driver bit and hand-tighten; avoid over-torquing which can strip threads
• Verify correct screw location and length before installation to prevent contact with internal components
• Disconnect power and water (if applicable) and follow appliance safety procedures before servicing