Thermador Range MEMW271ES Parts

Replace a faulty wall oven transformer when your oven won't power on or displays no lights. This internal electrical component steps down voltage.

90-degree connector cable for ovens and cooktops. Replaces damaged, frayed, or missing connectors. Essential for secure electrical connections.

This door latch assembly secures the door closed and signals the control that it's safely shut, allowing cycles to start and run. Replacing a worn latch restores a reliable safety interlock and consistent operation.

• Secures the door and engages the safety interlock so the appliance can operate
• Sends a "door closed" signal to the control
• Common symptoms: door won't latch or stay closed; unit won't start or pauses as if the door is open; intermittent operation when the door is bumped; visible wear or damage to the latch
• Helps prevent nuisance "door open" indications

• Disconnect power before servicing
• Access the latch from the door area; remove inner panel or trim as required by your model
• Note wire positions, transfer connectors, and mount the new latch in the same orientation
• Test door closure before reassembly

This small plastic clip secures internal components or wiring to the appliance chassis to prevent rubbing, movement, or noise. Replacing a worn or broken clip restores secure routing and reduces vibration-related sounds. What it does:

• Holds wiring harnesses or small parts in place to prevent chafing and wear
• Stops loose components from shifting during operation and causing rattles
• Helps maintain correct component alignment for reliable performance
• A broken or missing clip can allow wires or parts to contact moving pieces or hot surfaces

• Disconnect power to the appliance before starting any repair
• Clip typically presses into a matching slot or snaps over the component; no special tools usually required
• Handle small parts carefully; retain any removed fasteners for reuse
• If routing or mounting points are damaged, inspect surrounding parts for wear and replace as needed

Mounting screw secures internal oven components and panels. Replace if stripped, missing, or damaged during service. Essential hardware for reassembly.

Seals unused ports in your wall oven to prevent moisture and debris entry. Replace if missing, damaged, or leaking. Verify fit with your model number.

Replace a cracked, discolored, or missing light reflector in your wall oven. Installs behind the oven light bulb to direct illumination into the cavity.

This is an electrical noise filter installed inside the microwave to suppress electromagnetic interference generated during operation. It helps prevent the microwave from causing static or disruption to nearby electronics. Replace this filter if the microwave trips breakers, fails to start, or causes interference with other household devices.

Secures wall oven panels and components in place. Replace this mounting bracket when the original is broken, bent, or missing, causing loose panels or misalignment.

Halogen lamp bulb for wall ovens. Replace when oven interior light dims or fails. Verify compatibility with your model number before ordering.

Restores a tight seal between your wall oven door and cabinet. Replace if worn, torn, or causing heat loss. Confirm fit by model number before ordering.

Mounting bracket for microwave installation. Replaces broken, bent, or missing brackets that secure your microwave to the wall or cabinet structure.