Thermador Range PD364GDBS Parts

Burner won't light or clicks continuously? This spark ignition module generates the voltage needed to ignite gas burners. Moderate DIY repair.

If your burners won't ignite or flames are weak, a damaged gas supply tube may be blocking fuel flow. This 9-inch tube restores proper gas delivery. 2-hour DIY repair.

Oven light not working or flickering? This low-voltage transformer powers your range's interior lights. Restores proper oven lighting function.

This indicator light illuminates to show when a burner or oven element is active or still hot. It is mounted on the control panel and provides a visual safety alert during and after cooking. Replace this part if the indicator fails to light up when a burner is on, stays lit continuously, or appears dim and flickering.

This circular heating element is mounted around the convection fan at the rear wall of the oven cavity. It provides the heat that the fan circulates evenly throughout the oven during convection cooking. Replace this element if the oven does not heat properly in convection mode, heats unevenly, or if the element shows visible damage such as blistering, cracks, or burn-through spots.

Secures internal components to the range frame. Replace if bracket is cracked, broken, bent, or missing to restore proper alignment and stability.

Replace your cracked or faded control panel insert trim to restore appearance and proper button alignment. Fits into the control area for a clean look.

Fix leaks or flow issues in your range with this routing tube. Replaces worn or cracked tubes to restore proper liquid and airflow in your appliance.

Small hardware pin that secures or pivots components in gas ranges and cooktops. Replace if worn, missing, or broken to restore proper alignment.

This pressure regulator controls and stabilizes incoming water pressure to the appliance, helping maintain consistent operation and protect internal valves and seals. Fits systems that use a 3/4 inch inlet regulator. What it does:

• Reduces high incoming water pressure to a safe, steady level for the appliance
• Prevents pressure-related leaks, valve chatter, and premature wear on seals
• Helps maintain consistent water flow for reliable cycles and operation
• Commonly replaced when irregular pressure, humming valves, or water leaks occur

• One pressure regulator (3/4 in.)

• Turn off water supply and power to the appliance before starting; relieve system pressure first
• Inspect connection fittings and seals; use appropriate thread sealant if required by the OEM
• Tighten to manufacturer torque recommendations and check for leaks after restoring water

If your burner won't light or gas flow is weak, this valve controls fuel delivery to each burner. Moderate difficulty repair, typically 30-60 minutes.

Replace your cracked or missing range oven control knob. This slimline large knob installs on the control panel to operate oven functions. Ideal for worn or broken knobs.

Replace your range oven light bulb when it burns out or dims. Restores interior visibility for safe cooking. Verify fit with your model number.

Restore reliable baking performance with this bake heating element. Mounted at the bottom of the oven, it provides the primary heat source in Bake mode so the cavity reaches and maintains the set temperature for consistent results. What it does:

• Heats the oven in Bake mode to reach and hold the set temperature
• Failure can cause no heat in bake, very slow preheating, or uneven/undercooked results
• Visible cracks, blisters, or a broken coil indicate the element should be replaced
• A shorted element may trip a household breaker or blow a fuse

• One bake heating element

• Disconnect power at the breaker and allow the oven to cool before servicing
• Remove oven racks; take out the element's mounting screws and gently pull the element forward to access wire terminals
• Transfer wires one at a time to the new element; do not allow wires to fall back into the insulation
• Reinstall the element and panels, restore power, and test bake operation