Thermador Range PG486GGEBS Parts

Replace your cracked or faded control panel insert trim to restore appearance and proper button alignment. Fits into the control area for a clean look.

Small hardware pin that secures or pivots components in gas ranges and cooktops. Replace if worn, missing, or broken to restore proper alignment.

Fix erratic temperature readings or a stuck display on your range. This temperature display assembly restores clear temperature readouts and control feedback.

This pressure regulator controls and stabilizes incoming water pressure to the appliance, helping maintain consistent operation and protect internal valves and seals. Fits systems that use a 3/4 inch inlet regulator. What it does:

• Reduces high incoming water pressure to a safe, steady level for the appliance
• Prevents pressure-related leaks, valve chatter, and premature wear on seals
• Helps maintain consistent water flow for reliable cycles and operation
• Commonly replaced when irregular pressure, humming valves, or water leaks occur

• One pressure regulator (3/4 in.)

• Turn off water supply and power to the appliance before starting; relieve system pressure first
• Inspect connection fittings and seals; use appropriate thread sealant if required by the OEM
• Tighten to manufacturer torque recommendations and check for leaks after restoring water

If your burner won't light or gas flow is weak, this valve controls fuel delivery to each burner. Moderate difficulty repair, typically 30-60 minutes.

90-degree elbow orifice holder for gas ranges and cooktops. Replace this gas line connector if cracked, broken, or causing improper gas flow alignment.

Replace your cracked or missing range oven control knob. This slimline large knob installs on the control panel to operate oven functions. Ideal for worn or broken knobs.

Replace your range oven light bulb when it burns out or dims. Restores interior visibility for safe cooking. Verify fit with your model number.

Replacement selector knob for your range. Fits onto the control shaft to select functions, cycles, or heat levels. Needed when original is cracked, broken, or missing.

This gas tap controls the flow of gas to a burner or oven component on a gas range. It regulates the gas supply and ensures proper ignition and flame control. Replace this part if you experience gas flow issues, difficulty igniting a burner, or inconsistent flame output.

Replace your worn range door seal gasket to restore proper sealing and prevent heat loss. This flexible gasket creates a tight barrier around the door edge. Confirm fit with your model number before ordering.

Fascia panel for gas ranges. Mounts on the front control area. Replace if cracked, chipped, discolored, or damaged to restore appearance.

Natural gas oven burner orifice that meters gas flow for proper combustion. Replace if clogged, worn, or damaged to restore reliable oven operation.

Replace a cracked or missing spacer for your gas range. This small structural component helps maintain proper spacing between parts during installation.

Replaces the lower kickplate on your range to restore a finished look and protect internal components. Install when your original panel is cracked or damaged.