Thermador Range PG486GLBS Parts

Fix leaks or flow issues in your range with this routing tube. Replaces worn or cracked tubes to restore proper liquid and airflow in your appliance.

Fix erratic temperature readings or a stuck display on your range. This temperature display assembly restores clear temperature readouts and control feedback.

Replace your worn range door seal gasket to restore proper sealing and prevent heat loss. This flexible gasket creates a tight barrier around the door edge. Confirm fit with your model number before ordering.

Fascia panel for gas ranges. Mounts on the front control area. Replace if cracked, chipped, discolored, or damaged to restore appearance.

Replace a cracked or missing spacer for your gas range. This small structural component helps maintain proper spacing between parts during installation.

If your gas range broiler won't ignite or stays on continuously, the broil solenoid controls gas flow to the broil burner and may need replacement.

This pressure regulator controls and stabilizes incoming water pressure to the appliance, helping maintain consistent operation and protect internal valves and seals. Fits systems that use a 3/4 inch inlet regulator. What it does:

• Reduces high incoming water pressure to a safe, steady level for the appliance
• Prevents pressure-related leaks, valve chatter, and premature wear on seals
• Helps maintain consistent water flow for reliable cycles and operation
• Commonly replaced when irregular pressure, humming valves, or water leaks occur

• One pressure regulator (3/4 in.)

• Turn off water supply and power to the appliance before starting; relieve system pressure first
• Inspect connection fittings and seals; use appropriate thread sealant if required by the OEM
• Tighten to manufacturer torque recommendations and check for leaks after restoring water

Replaces the lower kickplate on your range to restore a finished look and protect internal components. Install when your original panel is cracked or damaged.

Secures your freestanding range to the floor to prevent tipping. Replace if bracket is missing, broken, or damaged during appliance installation.

90-degree elbow orifice holder for gas ranges and cooktops. Replace this gas line connector if cracked, broken, or causing improper gas flow alignment.

Removable floor panel that covers the bottom of your range oven cavity. Replace if cracked, warped, or missing to protect internal components.

Protects your range's blower assembly and directs airflow for proper ventilation. Replace if cracked, damaged, or airflow is restricted. Verify fit.

Gas range fixing kit secures components and prevents rattling or loosening. Replace when parts become loose or unstable. Verify fit with your model number.

This deflector redirects dishwasher spray to the rack and helps prevent the spray arm from hitting dishes. Replace a cracked or broken deflector to restore proper water coverage and reduce spraying issues. What it does:

• Directs wash water from the spray arm for better coverage of dishes
• Keeps the spray arm clear of obstructions so it can rotate freely
• Helps prevent water from spraying into areas it shouldn't
• Common symptom: visible damage, cracked or missing deflector causing poor cleaning or spray-arm interference

• Disconnect power and water supply before servicing
• Remove the lower rack to access the spray arm and deflector
• This deflector typically snaps or screws into place; use hand tools as needed
• Inspect spray arm and mounting area for debris or damage during replacement

This slimline grill knob is the replacement control used to adjust the grill function and heat settings on compatible units, restoring precise user control and a finished appearance. What it does

• Turns smoothly to select grill heat levels and activate grill functions
• Replaces worn, cracked, or non-responsive knobs that impede control
• Matches the slim profile used on select grill/control panels for a factory look
• Helps prevent accidental setting changes by providing a secure grip

• One replacement slimline grill control knob

• Pull the old knob straight off the control shaft; press the new knob firmly onto the shaft until fully seated
• Confirm shaft type (splined or smooth) before installing to ensure proper fit
• Disconnect power to the appliance before servicing electrical or control components