Thermador Range RDDS30VQB Parts

Rounded cap that sits over your gas cooktop burner to contain and direct flames. Replace if cracked, chipped, warped, or worn from high heat exposure.

Used to hold down the jet holder assembly.

Captures grease and cooking vapors to keep air fresh and prevent buildup. Replace when clogged or discolored. Verify fit by model number and dimensions.

If your cooktop burner won't heat or shows no signs of power, this dual-size radiant element restores both inner and outer cooking zones in 30-45 minutes.

This is an electrical relay used in ranges and ovens to control power to heating elements or other components. It acts as a switch that opens or closes a circuit in response to signals from the control board. Replace this relay if your oven or burner fails to heat, heats intermittently, or stays on continuously.

Jet holder assembly secures the orifice that meters gas flow to your cooktop burner. Replace if cracked, stripped threads, or missing nut components.

This upper snorkel limit switch detects the snorkel assembly position and signals the dishwasher control so cycles run correctly. Replacing a faulty switch restores reliable control of the snorkel mechanism and helps prevent cycle interruptions. What it does:

• Senses the upper snorkel position and sends a signal to the appliance control
• Helps prevent overfill or incorrect snorkel operation when working properly
• Faulty switch can cause cycle interruption, failure to advance, or snorkel-related errors
• Works as the control-point for the snorkel mechanism that affects water handling

• Disconnect power to the appliance before beginning any repair
• Turn off and/or disconnect water supply if required for access
• Remove access panels or trim as needed to reach snorkel assembly; handle clips and connectors carefully
• Test electrical connections and proper operation after installation

This is a small cap that fits over a push button mechanism on a range or oven control panel. It provides the outer surface you press to activate the control function. Replace it if the cap is cracked, missing, or loose, which can make it difficult to engage the associated control feature.

This right-side control panel endcap replaces a cracked, faded or loose trim piece to restore the dishwasher's appearance and help keep the control area protected from moisture and debris. It matches the OEM shape and finish for a clean fit. What it does:

• Replaces a damaged or missing right control-panel endcap to restore cosmetic appearance
• Helps keep moisture and food debris away from edges of the control panel
• Secures the control panel trim so buttons and switches align correctly
• Prevents further chipping or cracking around the control-panel edge

• Disconnect power to the appliance before servicing to reduce shock risk
• Typically installed by removing the outer door panel or release clips—do not force the part into place
• Keep OEM screws and retainers; replace any damaged fasteners for a secure fit

This left-side backsplash endcap is a replacement trim piece that restores a finished appearance and helps protect the backsplash edge from chips and wear. It matches the original white finish for a clean, factory look. What it does:

• Covers and protects the outer edge of the backsplash where it meets the side trim
• Restores a finished appearance after damage, discoloration, or loss
• Helps hold adjoining trim pieces in place and reduces visible gaps
• Commonly replaced when the endcap is cracked, chipped, loose, or missing

• High-level, no-specialized tools required for many models; follow OEM instructions for removal/installation
• Use care to avoid scratching the surrounding finish; support adjacent trim during replacement
• Always ensure cooktop/range is off and cool before working near the backsplash