Thermador Refrigerator T36IB70FSS Parts

This plate is a replacement support plate used in the appliance's internal assembly to secure and stabilize components. It restores correct positioning of attached parts so assemblies sit firmly and operate quietly. What it does:

• Provides a stable mounting surface to hold internal components in proper alignment
• Helps reduce movement and vibration of attached parts during operation
• Keeps assemblies secured to prevent rubbing or interference with other parts
• Supports reliable operation by maintaining correct spacing and positioning

• One replacement plate as shown

• Verify appliance is powered off and disconnected before starting any repair
• Inspect surrounding fasteners and mounting points; replace any damaged hardware
• Tighten screws to snug only—avoid over-torquing which can deform the plate

This is an active carbon filter designed to remove odors from inside the refrigerator compartment. It absorbs and neutralizes food smells to keep the interior air fresh. Replace this filter if you notice persistent unpleasant odors inside the refrigerator despite cleaning, or on a regular maintenance schedule as recommended.

Leveling foot installs at the refrigerator base to support and level the unit. Replace if worn, cracked, broken, or missing to restore stability.

Fix unresponsive buttons or blank displays with a new refrigerator control board. This interface module restores cycle selection and status information.

Replaces burnt out or dim refrigerator interior light bulb to restore clear visibility. Install when light fails to illuminate. Verify fit with your model.

Interior mounting plate for bottom-mount refrigerators and freezers. Replaces cracked, broken, or missing plates that secure internal components.

Condensate water container collects moisture from your refrigerator's cooling system. Replace if cracked, broken, or leaking to prevent water damage.

This replacement cover is a protective outer piece that helps keep internal components safe from moisture, dust and debris. It restores the original enclosure and helps reduce vibration and noise caused by damaged or missing covers. What it does

• Protects wiring, connectors and nearby components from moisture and contaminants
• Keeps small parts secured and helps prevent rubbing or vibration against moving components
• Helps stop visible rattling or scraping caused by a cracked or missing cover
• Useful when the original cover is cracked, warped, broken or otherwise damaged

• One replacement cover

• Disconnect power to the appliance before starting any repair
• Confirm orientation and clip locations before removing the old cover to avoid breaking fasteners
• Use gentle pressure to seat the cover; do not force broken clips—replace fasteners if needed