Samsung Microwave AMC2206BAQ Parts

• No heat

After dismounting the unit from its wall-hanging bracket, the most tedious part of the repair was removing over a dozen screws holding the cover in place from the top, bottom, and both sides. Fortunately, I had placed the unit on a bench that allowed me to slide the unit allowing access to the screws on the bottom edges of the unit. Always discharge the capacitor before continuing to work on the unit by discharging the capacitor by shorting the contact without the diode to ground. Access to the... Read more

Checked the three door switches; used ohm meter to see if there was resistance or if a switch was bad. 2 out of 3 switches showed resistance with the ohm meter. The last one tested (of course the last one) NO (normally open) did not show resistance; I.e. the ohm meter reading did not change when the switch was depressed. Appliance parts pros was the only company that had the same model number I was looking for (SZW-V16-FD-63). I ordered the relay switch, 2 days later it arrived (regular... Read more

• Won't start

I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more

I attempted to diagnose the four thermostats/thermal switches in the microwave....two right behind the control panel, one on top of the cooking cabin, and one under a metal shroud above the magnetron. While checking continuity with a voltmeter, i questioned one of them behind the control panel and the one above the magnetron. I then noticed a burn mark on the plastic connector sleeve for the one above the magnetron. I took a scrap piece of 14 gage copper wire and beat the ends flat with a... Read more

After receiving the part, I found I had to dismantle the left side of the handle in order to fix the right side that was broken. When I took the left side of the handle off I found the plastic piece that broke on the right side was about to break on the left side also. Having all the details and in advance of another broken handle, I ordered the part, just to have when it breaks. Read more

• Noisy

Bought a new motor. Read more

Removed microwave from the built in cabinet (probably the hardest part) and took off top cover (screws on side and back). Had previously blown the power fuse 2 times in this microwave, so I checked the fuse first using an ohmmeter. This time fuse was good. Traced the power wires around to top side of microwave and saw the overheat "therm" switch. I believe the therm is installed there as a safety feature to open the power circuit to the microwave in case something was to overheat for any... Read more