Samsung Wall Oven DTT36T960GM Parts

Secures microwave to mounting bracket. Replaces stripped, cross-threaded, or missing cage nuts. Installs inside cabinet housing for stable installation.

Burner cap that sits atop the auxiliary burner head on gas cooktops. Replace if cracked, chipped, missing, or damaged to restore proper flame distribution.

Replacement dual burner cap for gas ranges and cooktops. Sits in the center of the dual burner ring. Replace if cracked, chipped, missing, or worn.

Secures your range to its mounting location. Replace if screw is stripped, missing, or damaged to ensure proper installation and stability of your range.

Self-tapping screw secures panels, covers, and internal components in your refrigerator. Replace if stripped, missing, or damaged during repairs.

This is an electronic power supply module that converts and distributes electrical power to the various components in the refrigerator, such as the compressor, fans, and control boards. It is typically mounted on the back or inside the rear panel of the unit. Replace this module if the refrigerator is completely unresponsive, experiences intermittent power loss, or if the control board and compressor are not receiving proper voltage.

Replacement burner cup for gas cooktops and ranges. Sits beneath the burner to catch spills and protect the cooktop surface. Replace if cracked or worn.

Fix uneven flames or burners not igniting properly with this orifice holder. Secures gas orifice for proper fuel flow. Simple installation in 15 minutes.

This burner head assembly replaces a damaged or worn mid-right gas burner head to restore proper gas flow and flame pattern on compatible ranges. It fits into the cooktop to deliver an even, controlled flame for cooking. What it does:

• Directs gas from the valve to the burner ports so the cooktop produces a consistent flame
• Helps restore even heating when a burner has weak or irregular flames
• Can stop symptoms such as a burner that won't light reliably, produces yellow/sooty flames, or has uneven heating
• Works with the existing burner cap and cooktop components when the correct assembly is installed

• One mid-right burner head assembly

• Turn off the gas supply and disconnect power to the appliance before beginning work
• Remove grates and burner caps, then lift out the old burner head and seat the replacement securely
• Check for proper alignment with the burner valve and ignition electrode; reassemble grates and test for correct ignition and flame pattern

Replaces a missing or damaged tapping screw in your dryer. Used to secure internal panels and components. Essential for reassembly after repairs.

Metal fastening screw secures panels, trim, and internal components. Replace missing, stripped, or damaged screws to restore proper fit and stability.

Adhesive rating label nameplate that displays model number, electrical ratings, and certifying marks. Replace if worn, faded, or peeling.

Flat bolt for microwave/hood combo units. Secures appliance during installation. Replace if bolt is stripped, missing, or damaged during mounting.