Parts for Kitchenaid KCC1500: 03 - Powerscrew And Ram Parts

This part has been discontinued by the manufacturer and is no longer available.

This is the left side frame slide. For right side use W11722978.

The Roller Assembly is an OEM replacement part for Whirlpool and KitchenAid trash compactors. It includes dual plastic roller drums that grasp and compact trash inside the waste cylinder. The assembly comes with 2 rollers. 

Causes of faulty or worn rollers include years of continuous daily use compressing a wide variety of trash materials. 

Symptoms include:

• Inability to fully compact bags into tight, uniform bricks  
• Loose, inefficient compaction allowing excess empty space
• Excessive odors escaping around poorly compressed bags
• Visible cracking or flat spots on roller gripping surfaces

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Size: 3\8-24 inch.

Size: 6-32 x 3/8 inch.

Size: 8 x 1/2 ab.

Size: 8-32 x 1/4 inch.

The Directional Switch is an OEM part for Whirlpool trash compactors. It controls the direction of the compactor ram, enabling it to move up and down to compress trash effectively.

You should replace this directional switch if it becomes defective. Common causes of a bad directional switch include electrical failures, wear and tear from frequent use, or damage due to power surges. These issues can impede the proper operation of the trash compactor, leading to inefficient trash compression.

Symptoms of a bad directional switch include:

• The compactor ram not moving up or down
• The compactor not starting or stopping correctly
• Unusual noises coming from the compactor
• The compactor getting stuck in one position

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models

Size: 6-20 x 1.0 inch.

This part has been discontinued and is no longer available.

This replacement leveling wheel restores a dryer/washer cabinet's ability to sit level and roll smoothly during adjustment. It helps stop wobble and ensures the appliance can be properly leveled for stable operation. What it does:

• Replaces a worn or broken leveling wheel on the appliance base or leveling assembly
• Allows the cabinet to be adjusted up or down when setting appliance height
• Helps reduce rocking, uneven vibration, and unstable operation caused by a damaged leveler
• Works with the appliance's leveling hardware to keep the cabinet properly supported

• One replacement leveling wheel

• Disconnect power and water before beginning any work
• Support the appliance securely to relieve weight from the leveling assembly before removal
• Remove the old wheel from the leveler shaft and press or snap the new wheel into place; use basic hand tools as needed

Size: 10-24 x 3/8 inch.