Parts for Frigidaire 6338A: Pump And Drive Components Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This O-ring is a small rubber seal that prevents water or air leaks at a connection point. It restores a tight seal so appliance lines and fittings work reliably and avoid drips or pooling. What it does:

• Seals joints and fittings to stop water or air from leaking
• Commonly replaced when a connection shows visible leaking or moisture
• Helps restore proper water flow and pressure by removing escape paths
• Useful when replacing related fittings, valves, or tubing to ensure a leak-free seal

• Disconnect power and shut off water supply before replacing the O-ring
• Remove the old O-ring, clean the sealing surfaces, and inspect for damage before installing the new ring
• Lightly lubricate with a water-safe (non-petroleum) lubricant if needed to ease installation and prevent pinching

This pump cover is the molded housing that protects and seals the washer's drain pump, directing water flow and helping prevent leaks. It restores proper drainage and containment around the pump assembly. What it does:

• Covers and seals the drain pump to maintain proper water flow through the pump area
• Helps prevent leaks from the pump chamber and surrounding cabinet
• Keeps pump components aligned and protected from debris
• Can reduce pump-related noises caused by loose or damaged housings

• One pump cover

• Disconnect power and shut off the water supply before servicing
• Drain any remaining water from the tub/hose to avoid spills
• Access typically requires removing the washer access panel or cabinet; handle clips and fasteners carefully
• Inspect and replace any worn gaskets or seals when reinstalling to ensure a watertight fit

The Spin Bearing Washer is an OEM part for Frigidaire washing machines. Situated inside the transmission housing, this thin metal washer acts as a subsurface support for the belt pulley bearing. The spin-bearing washer facilitates smooth, balanced rotation essential for agitated and spun wash cycles.

Causes of a bad spin-bearing washer include wear and fatigue from years of successive rotations, potentially allowing excessive movement between housing components.

Symptoms of a bad spin-bearing washer involve:

• Vibration or shaking noises coming from inside the washer cabinet
• Belt slippage wasting energy by inefficiently spinning loads
• Increased friction resulting in longer cycle times for spins
• Failure of belts or other components from unsupported bearing

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This is a small C-clip or retainer ring that secures the idler pulley to its bracket on a laundry center. It keeps the pulley in place so the drive belt maintains proper tension against the drum. Replace this ring if the idler pulley has come loose, the drum belt slips or falls off, or the dryer drum does not spin properly.

Replacement drum drive belt for washers. Transfers motor power to spin the drum during wash cycles. Replace if drum won't spin or belt shows wear.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.