Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Dishwasher Detergent Dispenser by Bosch

Best Seller
Manufacturer Part
4.89 (64)
By: Bosch
Part Number: OEM17954820
Manufacturer Part Number: 12008380

Fix a detergent dispenser that won't open or leaks rinse aid. Replaces the complete dispenser assembly. Moderate DIY repair with video guide.

More
$60.55

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Bosch Dishwasher Detergent Dispenser (Part Number: OEM17954820)

1 Answer

Allen, with the front door panel removed, the detergent dispenser 12008380 would need to be tested for a 165 Volt DC pulse during a quick cycle. There should be one pulse to open the detergent door, then more pulses for the rinse aid dependent on what the rinse aid setting is set to. If the setting has not been changed, there should be 5 pulses after the detergent door opens. This should dispense 5 ml of rinse aid (1 ml per VDC pulse). If the voltage appears more than it should, the user interface control 11031129 would be the cause of failure. If the correct amount of voltage pulses occur, the setting can be adjusted using the use and care guide to a lower number. If the problem still persists, the dispenser would be the cause of failure.

Read More...

1 Answer

Rmarlais,
The model number is incomplete as the two-digit series number has been left off. Based on the information provided, the manufacturer part listed for your machine would be 12008380 / 12008380

Read More...

1 Answer

Bianca, the dispenser 00645208 would need to be tested for DC voltage to identify if it is receiving voltage continuously during a wash cycle. If it is receiving voltage throughout the wash cycle instead of only at the rinse portion, the control module 00752739 has failed. If it is not receiving constant voltage, the dispenser would need to be replaced.

Read More...

1 Answer

Dee, an adhesive or sealant would not be necessary as the rubber seal is designed to properly seal it.

Read More...

1 Answer

Ramesh,

The wax motor will not be sold separately and will need to replace the dispenser assembly.

Read More...

1 Answer

Jonathan,

Unfortunately there would not be a video on how to replace the dispenser but all you would do is remove the screws from the inner door panel and the front panel will come off. This will give access to the screws that hold the dispenser in place. Remove the screws take out old dispenser and install the new one.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google