Need Help?
Call or text
Dispenser door won't open or stay closed? This dishwasher dispenser releases detergent and rinse aid at the right time. Moderate DIY repair.
Process was a bit more complicated than the videos I had watched online. Had to remove both front panel and control panel to get to soap dispenser. Removed wires to soap dispenser and rinse aide dispenser. Removed wire "harness" around the top and right side of dispenser. Pried back the clips to allow dispenser to be pushed out. It was helpful to have another person to hold the door open at this point. Bent clips back and reinstalled everything. New part works great. Read more
Fix a detergent dispenser that won't open or leaks rinse aid. Replaces the complete dispenser assembly. Moderate DIY repair with video guide.
Replaced dispenser Read more
Fix a rinse aid door that won't stay closed or causes leaks. This dishwasher dispenser door with gasket snaps on in minutes. Easy DIY repair.
Twist the old one out, insert tab, twist until other side snaps in. Easy as pie after watching the video! Read more
Detergent dispenser door won't stay closed? This latch secures the detergent cup during wash cycles. Simple DIY repair with video guidance included.
After having seen the video I installed the new lid and it worked. Read more
Fix a detergent dispenser door that won't stay closed or pops open during the wash cycle. This lid replacement is a simple DIY repair with no tools needed.
Detergent door won't close or stay shut? Replace the dispenser assembly. Takes about 20 minutes with basic tools—remove inner door panel and swap out.
Removed back of dishwasher with hex screw driver 5 min Unplugged power cord 30 secs Loosened metal bracket on top and bottom with screwdriver 5 min Pushed dispenser in and removed from dishwasher 5 min Positioned new unit in space and snapped into place 1 min Plugged electrics back in 1 min Screwed back on 3 min Roughly 20 min. I am nontechnical and rarely do repairs. Read more
Plastic cover that protects the drain pump mechanism from debris. Replace if cracked, broken, or tabs are bent preventing proper seal during drain cycles.
Watched AppliancePartsPros video, disassembled the dishwasher and replace impeller and seals. Read more
Wax motor for detergent/rinse-aid dispenser.
Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more
Detergent not dispensing during wash cycle? This actuator arm with spring releases the detergent cup at the right time. Moderate DIY repair.
Ordered a replacement control panel and installed it according to the AppliancePartsPros.com YouTube video. Read more
Rear pump housing for the washer drain/pump assembly. Replaces the worn rear housing that supports the impeller and bearing, helping restore proper draining and reduce leaks or unusual pump noises when the housing fails. What it does:
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger. When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed... Read more
Rear pump housing that encloses and aligns the drain pump assembly. Replace if cracked, warped, or damaged to restore proper water channeling.
The pump impeller came apart so it was not pumping the water and making noise. The dishwasher came apart easy but the gasket to the sump assembly stayed attached to the bottom of the tub and did not pull it off. I was running my thumb around the gasket to see if it was in good shape or if I needed to replace it and sliced my thumb open on the sharp edge of the tub opining. So a $150 later for Emergency Room visit and a sore thumb I re assembled the dishwasher. Be careful of sharp edges in this... Read more
Replaces a cracked, broken, or missing detergent dispenser cover on your dishwasher. Snaps onto the dispenser assembly to keep detergent secure.
Replace your dishwasher's detergent dispenser lid if it's cracked, broken, or missing. This cover installs on the dispenser assembly to seal properly.
Bought new dispenser lid with gasket and installed in despensor! Read more
Replacement water level control cover for dishwashers. Snaps over the water level control assembly. Order a new cover if yours is broken, cracked, or missing.
This replacement lid is the outer cover used to protect internal components and help contain water and debris. It restores a finished appearance and helps the appliance operate without interference from loose or damaged tops. What it does:
Replacement front cover for dishwasher control module. Needed when plastic is cracked, broken, or switch actuators are worn or missing. Protects control board.
I had to replace the plastic schell around the control modguie, manufacture wanted to sell you the complete modgule Read more
Usually ships within 4 - 14 days