Deanna May 19, 2015 for Model Number pcg364el/01 I was told I need the control board for this since my blue indicator light stays on all the time. I am thinking the correct part number is 00619016 not 100% sure. Is this true?
1 Answer Deanna, The control board that would be needed is part number 00600335 which is the main control. Read More...
Joe February 14, 2015 for Model Number PRL364GDH/03 I have a thermador range model # PRL364GDH/03 the left side both burners XLO side, the ignitors keep clicking in the off position both of them when the burners are lit it stops when turned off the both start igniting
1 Answer Joe, For this issue you will need to get the potentiometers 00629722 and simmer control 00619016. Read More...
Ken Smith December 04, 2014 for Model Number prg304eh/04 The left two burners don't click and no gas, would that be simmer control board ap4509942?
1 Answer Ken, Yes the simmer control would be the issue with the unit but the part number for the simmer control is 00422882. Read More...
Joann S March 22, 2014 for Model Number PRG366EH/04 My XLO burners on this Thermador oven when shut off, continue to make the clicking sound. When the burner cap and tray are removed it exposes the PCB control board. There is a jumper on the board that I have. I called a technician and he told me that jumper was no longer required and he removed it. The burners still make that noise, so it disconnected the total unit.Your customer service gave me a part number AP4509942 for the board. Is this a correct replacement? Usually a jumper on the board fixes an existing problem, now I can't use either of these XLO burners. Please help.
1 Answer Joann, The jumper wire is required for the board and you could either get a new board 00619016 or make a jumper wire for the board. As far as the clicking noise that continues, this would most likely be caused by a bad potentiometer. The part number for this would be 00647864. Read More...
P.V. November 17, 2013 for Model Number pg366bs When trying to use my thermador extra low burners they cause both xtra low burners to fail after a few minutes. I disconnected part number 423093 (solenoid) to stop but the other burners from tripping off. I replaced the solenoid with a new one and that did not solve the problem. What other part controls both burners. I am leaning towards the control unit, part 605350 (Control Simmer Module).
1 Answer Hello P.V., The simmer control 00619016 is the next thing to be suspected so you are on the right track. Read More...
Kurt March 20, 2013 for Model Number PRL486EDG/07 I am installing P/N 619016. The board is mounted with four plastic devices. How do I remove these and mount the new ones? Hopefully I don't need access to the back of the mounting surface
1 Answer Hello Kurt. You will use needle nose pliers and squeeze the tabs to close them and pull off the board. Look closely and you will see how to do this. Read More...