Dave November 13, 2017 for Model Number SHE65T52UC/09 I have the dishwasher with the 3rd rack. I need the stopper hook for the 3rd rack. I ordered it but was sent the stopper hook for the regular rack which is larger and does not fit. The schematic does not show the part number for the SMALLER 3rd rack stopper hook. Thank you.
1 Answer Dave, The only way to get the rack stops would be to get the rail which would be part number 00744815. Read More...
Carol April 16, 2012 for Model Number boschshe55m15uc/64 I need to know the part number to the part that holds the upper spray bar to the basket. The clip broke. Thank you.
1 Answer Carol, the parts to the upper spray arm are not available separate. Your part number is 00676933. Thanks! Read More...
Jim M. March 20, 2012 for Model Number shu3322UC/12 I need the end piece that goes on the left side (if looking into dw) of the lower rack and holds and locks the rack upright. In my dishwasher it appears to be rectangular and there is one for each set of lower rack tines.
1 Answer Jim, I believe the part you are looking for is the flip lint latch part number 00167273. Thanks! Read More...
John February 26, 2012 for Model Number Bosch Dishwasher model # SHE68r55UC I need to order a few clips that hold the plate holder racks to the main bottom rolling frame. They are about 1 inch long and have an indentation on both ends.
Amy P. February 05, 2012 for Model Number shx98m05UC/49 I need the small part that attaches the plate holder to the bottom shelf as described above but there is no half moon. Thank you.
1 Answer Hello Amy! The lower rack tine holders is part number 00428344, 00418498, and 00428344. Thanks! Read More...
Andrea January 10, 2012 for Model Number bosch I need the little clip that keeps the rack in place. Its not the clip on the end its the one in the middle.
1 Answer Hello Andrea. We will need your model number to help you with this. Thanks. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Virginia November 30, 2011 for Model Number SHX57C06UC/21 I need the part that holds the plate holder to the side of the rack so that the plate holder is vertical. There is a little piece that broke. The rest of the part is kind of a half moon shape. Can you tell me what part I need? Thanks.
1 Answer Hello Lisa. You will remove the old end caps from the rack rails, and clip the new endcaps 00165254 in place. You will see where the tabs hold them into place. Hop this helps. Read More...