Doug August 08, 2022 Is there a newer version that would work since this panel is no longer available? Thanks
1 Answer Doug, unfortunately, the manufacturer has not provided an approved substitute part number for the discontinued panel base 00684150. As this is the case, we would not be able to guarantee that an alternative would fit properly. Read More...
Bob June 24, 2020 for Model Number wfvc6450uc/26 Please tell me how to install front plastic cover-it has tabs that will go into slots in metal frame-but screw slots at bottom of plastic have only cutout-no hole for screw to attach plastic to metal frame-part # ap4509461-thank you
1 Answer Bob, the screws 00617527 at the bottom should have a wide enough head that would secure the base panel once tightened onto the cutout channel of the panel. Read More...
Jim November 05, 2019 for Model Number WFVC6400UC/19 My old washer bottom panel had broken mounts for the attachment screws to go through I just received my replacement panel and it does not have a mount for the screws to go through. In fact it looks just like my broken one, my old one is obviously broken and the new one is not. Do the new panels have another part that attaches to the panel that allows it to be attached to the washer. Thanks, Jim
1 Answer Jim, the front base panel will have three tabs that angle in and have a hole in the center of each. The unit will need to be tilted back and propped on a block to allow the base to be placed in and pushed up into the frame mounting slots. Once this has been done, the three tabs will have the screws placed to secure the base up on the frame. Read More...
Bill August 14, 2018 for Model Number BOSCH clothes washer WFVC3300UC/19 to get at the drain trap, I assume the lower panel/kick panel needs to be removed? I see 3 torques screws holding that panel; what size torques are they? the problem is an E-13 code-- door is locked and it will not drain, on-line I see to check the drain water line & pump... but I always can assume a possible problem with the control panel too.
1 Answer Bill,Torx is a t20 but behind that panel you will not be able to access the drain pump.The whole front cover will need removed i will email an attachment for part removal.If damage has occured to drain order part # 00436440.Check for 120 volt when trying to drain.If you have voltage your control is good. Read More...
Wayne April 02, 2018 for Model Number WFVC540SUC/20 I'm looking to buy this kick panel, but i need it in gray not white. Is that part available?
1 Answer Hello Wayne, we show the manufacturer listed for your model number part number 00684472. Thanks! Read More...