Kevin B November 14, 2022 for Model Number Frigidaire Gallery GLEF396AQC The right front burner will not turn off. I unplugged the range from the outlet and when I plug it back in the burner comes on right away and will not turn off. What part do I need to fix this? Thank you for any help!
1 Answer Kevin B,Thanks for the question. Based on the information provided the likely issue would be the user interface board for the element in question. 316239500 Read More...
Rich April 04, 2022 for Model Number GLEF396CSA FRONT LEFT BRIDGABLE ELEMENT NOT WORKING ... THE CENTER AND REAR ELEMENT DO WORK .... WHEN TURNING THE KNOB CONTROL ... YOU CAN HEAR SOMETHING CLICK ON LIKE THE THERMOSTAT ... SO I THINK THE KNOB ASSY IS WORKING ... HOW DO YOU REMOVE THE TOP GLASSSECTION TO EXPOSE THE ELEMENT SO I CAN OHM IT OUT AND RULE IT THE PROBLEM OR NOT ... THANK YOU IN ADAVANCE ....
1 Answer Rich, To remove the main top of the unit, disconnect power from the unit, open the oven door and at the top of the opening, there will be screws you will need to remove. Once removed you will be able to lift the main top of the unit off. Read More...
Deborah April 16, 2018 for Model Number 790.99012100 The right front dual burner stays on all the time in the small setting. The outside ring works fine. I think I might need the switch, 316239600 as the burner itself ohms out fine and has not visual damage. The wiring diagram is confusing me, is there a relay board for the surface elements as well? Thanks, Deb
1 Answer Hello Debra. Make sure the control knobs are not bad. If not, then it sounds like the surface control 316239500 will need to be replaced. Thank you. Read More...
Ric October 27, 2015 for Model Number PLEF398CCB The front right burner on the range would not turn off. Is this more likely to be the Element Control Switch (PS2373492), or the Electronic Control Board (PS2373490)? How can I confirm which part is at fault?
1 Answer Rick, The burner not shutting off would most likely be caused by a stuck relay on the control board 316239403KITK. Read More...
Pat November 01, 2013 for Model Number plef398ccd The element control switch has a cracked or broken light grey threaded piece. Do I have to replace the whole control switch or is that grey threaded piece replaceable?
1 Answer Hello Pat, The complete switch assembly 316239600KIT would require replacement since parts of the switch are not available without the switch assembly. Read More...
Mike W. October 13, 2013 for Model Number fef352awc When useing the front left element it will heat up to high without turning the knob.
1 Answer Hello Mike, This is most likely the infinite switch 316436000. There is the possibility of a shorted wiring harness but this is not as likely as a bad switch. Read More...
1 Answer Hello Mel. If the relay is sticking on the control, you will need to order and replace the control board 316557118 on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Hugues L. April 24, 2012 for Model Number CPLEF398CC (buy in canada montreal) Hello. I need to replace my element control for my stove. The number of your part and the one broken on my stove are similar 316239600 but on the picture the last 4 digit does not match my broken one 0422. Will your part fit my model? Thanks.
1 Answer Hugues, we do not have any information on model CPLEF398CC. With this being a Canadian model you will have to contact the manufacturer for parts assistance as we do not have information on all international models. Sorry about that! Read More...
Mac7707 December 27, 2011 for Model Number GLEF396ASA My frigidaire Range has one burner that will not shut off. From what I have read it is the control board (ERC) because it has an error code F7 that stays on . None of the other burners will come on except the warming element. I unplugged the unit and let it set. Plugged it back in it flashed PF power failure then it switches to Ft. Can you give me any advise as what to order to replace if it is the ERC. Thanks Mac.
1 Answer Hi Mac. The F7 is a circuit board interuption code. The control board is part # 316207600. Thank You. Read More...