Michael April 02, 2021 for Model Number FDB750RCC2 Frigidaire Ultra Quiet III FDB750RCC2. One heating element terminal burned and took the connector lead setup with it. The wire is still attached to the high limit thermostat but burned terminal end of the wire is dangling. I need either the whole wire connector going from high limit thermo to heating element terminal, or just the terminal end and I can splice. Can I get this specific wire connector by itself, or is it included in the whole wire harness kit? Thank you
1 Answer Hello Michael, You will need harness 154646201 for the model provided. I'm sorry but we have no images of the connectors so we are unable to provide parts for a possible repair. Thank you for your patience and understanding in this matter. Read More...
Kyle November 15, 2017 The brass nut was cracker which led to corrosion on the heating element and wire. Do you sell the wire that connects to the heating element?
1 Answer Hello Kyle. You will need to order the wire harness for that wire that is needed. Thank you. Read More...
Marie March 08, 2017 for Model Number 58714013401 Hi, I need to replace the heating element because my dishwasher was leaking, but it was leaking inside the electronic parts too and I can't figure out how to find those to replace them.
1 Answer Marie, If the unit was leaking into electrical parts under the unit then this would be the circulation pump 154859201 and drain pump A00126501. Read More...
Wayne September 28, 2014 for Model Number PLD2560LCC1 Heating element does not heat. Is there any relays that I should check besides the thermostat.
1 Answer Wayne, You will want to check the control to make sure that it is sending power to the heating element and make sure that the wiring between the control and the heater check ok. Read More...
Don December 14, 2013 for Model Number fdb510lcs2 What part or parts do I need to fix this dishwasher that leaks around the holes where the heater element goes through the tub?
1 Answer Hello Don. You will need to replace the brass nuts 154106202 if they are cracked and are leaking. Read More...
Brenda October 22, 2013 for Model Number MDB122LBS1 We have the hot water hook up to the dish washer, but the water is cold when the washer is washing. We have tried to let the hot water run for a while and then turn the washer on. All the water is cold. The heating element is not getting hot either. What could be causing this problem?
1 Answer Hello Brenda. You need to check the hot water connection. Make sure there is hot water coming into the unit. Also, test the heater, thermostat, and board on the dishwasher. Remember, it DOES NOT have the ability to heat up cold water. Read More...
Brenda October 21, 2013 for Model Number MDB122LBS1 Dishwasher is working find other than the heat dry . Is this a heating element problem or something else?
1 Answer Hello Brenda. You can test the element and the thermostat. Both should read closed for continuity. If they are good, you will need to order and replace the control board on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Kelly August 01, 2013 for Model Number tbd210rfb1 How can you tighten or fix the heating element? It is loose under the bottom and appears to be stripped and it has never been touched other than installation.
1 Answer Hello Kelly. You will need to order and replace the heater nut 154106202 on the unit. Your old one is cracked. Read More...