Barb November 27, 2020 for Model Number Frigidaire stackable washwe/dryer. Stackable washer and dryer,want to make side by side. Need extension hose for washer to reach drain.
1 Answer Barb, if the model number of the washer could be provided in a new question, this will allow for the best information possible as there may be a longer hose. Otherwise, a drain hose extension similar to DRNEXT4 may work. Read More...
John October 15, 2018 for Model Number 41794712400 Hello this is John again. I was wondering if anyone could answer the second part of my previous question. On what slot/space should the springs go on these adjusting inserts? Do you guys know on which slot/space do they come from the factory settings? Thank you again :o)
1 Answer John, The factory setting on the insert is the middle slot. That's where you would want to place the spring and adjust from there, if necessary. Read More...
John October 14, 2018 for Model Number 41794712400 On my Kenmore laundry center there is 3 springs that connect to the chassi. I believe only the 2 rear ones utilize these adjuster inserts. I noticed my washer is missing both those inserts, and I’ve also noticed that my tub vibrates/whobbles a bit more than your usual tub during the spin cycle. Do you guys think that using these inserts will help with that vibration/whobble? Also...in which slot of the insert should the spring go? Is there a factory slot setting on these? Thanks for your help?
1 Answer John, Yes if these inserts are missing it could cause the unit to vibrate and wobble more than normal. Read More...
Fast Rabbit May 16, 2012 for Model Number FLGB43RGS2 There are 3 springs holding the tub to the chassis and tube - pressure # AP2140345 between springs and bracket on chassis, but drawings don't show them attached. I serviced a machine that didn't have the mentioned tube - pressure on the front spring, is this right or there should be 3, one on each spring? Thanks.
1 Answer Hello! I do apologize for the confusion, part number 5303212877 should be listed as a spring adjuster insert- not a pressure tube. According to the part lists there should be three of these used on your appliance however, the manufacturer does not list this part in the actual diagrams. This install on the springs 134885900 and 134886600 that hold the tub to the chasis. Hope this information helps, thanks! Read More...